Van Alstine rev 2 ABX Switch Manual - page 6
A/B Switch 20X2 Rev2 Remote Control Reference Sheet
1-1-14
On-off
Qualifier
Vol Up/Dn
Adjust L & R volume
Chan Up/Dn Balance…Adjust either L or R volume
Prev Ch
Toggle selected side for volume adjust
Mute
Toggle Mute mode (mute allows volumes to be set with speakers off)
1 Select A Source
2 Select B Source
3 Toggle Source
4 Select A Amp
5 Select B Amp
6 Toggle Amp
7 Select A Speaker
8 Select B Speaker
9 Toggle between A and B speaker
0
Select C Speaker
Enter Selects “enter” system previously defined by on-off then Enter
Input Selects “input” system previously defined by on-off then Input
On-off Enter
Define currently selected system as the “enter” system
On-off Input
Define currently selected system as the “input” system
On-off Vol Up/Dn Adjust display brightness up/dn (VFD display only)
On-off Chan Up/Dn Adjust display brightness up/dn(VFD display only)
On-off mute
toggle IR display mode (if on, received IR command is displayed on VFD)
On-off 1
go to Blind Test mode (operates with “enter” and “input” systems)
On-off 0 or stop
exit Blind Test mode
Play toggle subwoofer enable. “SUB” displayed if enabled. Enabled implies there is a 6db per
octave high pass filter on the speaker outputs, disabled implies speaker outputs are direct.
Stop toggle quick blind test mode: Front panel LED’s off, display volume reads “00”.
On-off Rec (twice) write current state of ABX switch to memory to set power up state.
FF
sub volume adjust. Allows setting sub volume different from normal volume.
REW
not used
The following keys deal with multiple units being controlled with one remote
Pause
Pressing the “pause” key multiple times cycles the display mode to show unit number,
xmit number, and normal display mode. A “*” indicates unit is currently selected.
Normally the unit number is set to 0 (accept commands from any xmit number) and the Xmit
number is set to 0 (send commands to all unit numbers). When the unit number does not
equal the xmit number the ABX switch is not selected (indicated by “NS” in the corners of
the display). By properly setting the unit and xmit numbers, a single remote can control up
to 9 different ABX switches.
Pause (1 / 2 times) >> 0-9 key >> Rec (twice if RCA remote) will set unit / xmit number and save to eeprom