Van Mechelen Partner LM15 User Manual - Contents of Packing
2
Contents of packing
Prior to taking into operation your LM15 monitor, please check
whether the following parts are included and undamaged:
1
LM15 Monitor
1 CD with touchscreen driver
1
Operator's Manual
3
Installation of the LM15 Monitor
The following steps are necessary for the device to function properly:
1
Switch the computer OFF.
2
Connect the LM15 monitor to the computer. (For best results, set
the computers screen resolution to 1024x768).
3
Switch your computer and the monitor back ON.
4
Adjust the display for the graphic card in the computer by means
of the On Screen Display (OSD) AUTO TUNINGfeature. This step is
important for getting the best picture quality. (section 5.2)
5
(Touchscreen Monitor Only) Install the touchscreen drivers for the
corresponding operating system (chapter 4).
Note: The LM15 must be used with the power adapter provided.
3.1
Cable Installation
The installation of the cables must be done with the computer
switched off. Begin by connecting the VGA cable, the RS232 cable,
audio cable then the power cable.
Once connected, turn the LM15 monitor ON. After about 3 seconds, you
should see the LED on the front panel light up green followed by an
image on the screen.
Important Note:
If the computer is in suspend or standby mode the LED will be red.
If the SVGA cable between the Monitor and computer is disconnected,
the LED lights up red.