Van Medevoort DA468 Instruction Manual - page 3
vM DA468 STEREO DIGITAL / ANALOG CONVERTER
2
BEFORE GETTING STARTED
IN GENERAL
When using your Van Medevoort product make sure that the following is observed:
- The cooling air vents are not covered
- The air can move freely around the product
- The product is sited on a vibration-free surface
- The product is not exposed to (very) high temperatures, cold, moist or dusty
environments
- Do not expose the product to direct sunlight
- Do not expose the product to electrostatic discharges
- Never put any type of object directly on top of the product
When in doubt do consult your Van Medevoort dealer. If any object and/or water
and/or moisture should find its way into the unit, always disconnect the power cord
by its plug, never by the cord itself.
When leaving for extended periods, e.g. holidays, we strongly recommend that you
unplug all audio equipment. This is also advisable when there is a thunderstorm or
lightning.
CONNECTING
Before actually making any connections, always disconnect the power cord from the
wall socket by its plug, never by the cord itself, or switch the productOFF.
Always connect one source at a time and make sure that the output Left & Right
channels are not interchanged.
Make sure that the plug is fitted correctly. Otherwise, hum and/or noise may be
apparent.
DO NOT forget to read the respective manuals of the products you wish to connect
to this product, BEFORE connecting.
POSITIONING
If this productis being used at the same time as e.g. a Computer and/or a TV-tuner,
you may experience various anomalies. When this is the case, please follow these
instructions:
- Position the product as far away as possible from this type of item
- Make sure that the tuner interconnect is detached as far away as possible
from all radio and/or TV power cords.
- Usually these anomalies occur when a 300 Ohms cable is used. We advise
you to change to a well shielded 75 Ohms cable.