Vanatoo Transparent One Quick Start Manual

4.  Connect the wire with the 

unmarked insulation (no white stripe) to the black terminal 

using the same process.

Turn screw cap counter 

clockwise until the hole in the 

inside post is fully visible.   

Thread the exposed wire 

through the hole until the top 

of the wire clears the hole. 

It might be easier to thread 

upwards from the bottom. 

Hold the wire in place, and 

with your other hand, turn the 

screw cap clockwise to tighten 

the screw cap back down until 

the wire is securely in place. 

Quick Start Guide

Vanatoo transparent one

™ 

powered speakers   

™

1

2

Unpack your system

1. Active speaker

2. Passive speaker 

3. AC power cable 

4. 3.5 mm to 3.5 mm cable

5. 3.5 mm to RCA “Y” cable

6. Speaker wire

Connect the speaker wire

Connect the speaker wire to the active speaker

1.  Locate the red and black terminals on the active 

speaker. 

2.   Locate the length of speaker wire with the white stripe. 

3.  Connect the wire with the 

white stripe to the red terminal:

1

2

Connect the other end of the speaker wire to the passive 

speaker

1.  Locate the red and black terminals on the passive speaker.

2.  Repeat the steps performed on the active speaker. Make sure 

terminals of the same color are connected using wires with 

the same marking

(e.g. striped wire on the red terminals, 

and non-striped wire on the black terminals).    

2

1

To prevent the possibility of shorting the terminals, make sure the exposed sections of 

speaker wire do not touch during installation or operation. 

When tightening the speaker terminal screw caps, make sure that 

only the exposed 

speaker wire is clamped between. This will create a secure working connection. 

The speaker terminals on the active speaker are OUTPUTS. DO NOT connect the 

output terminal of a stereo amplifier to these terminals. 

!

WARNINGS

TURN OVER

4

3

1

2

5

6