Vanco EVMX44QI Manual - Www.Vanco1.Com

www.vanco1.com

800.626.6445

9

CONFIG Switch   

Please see below table to set the matrix with different configuration mode by front panel CONFIG switch.

EDID dynamic selection function

The 4x4 matrix has internal EDID management to support HDMI display terminal. EDID dynamic selection 

when 2 or more HDMI display terminals choose the same HDMI source. There are two different EDID dynamic 

selection modes, one is to choose the lower definition EDID as current EDID, and the other is to choose 

the higher definition EDID as current EDID. The user can set “CONFIG” switch 1 to select EDID mode, when 

“CONFIG” switch 1 is set as “o ” (default mode), the matrix will choose the lower definition HDMI display 

terminal EDID, when “CONFIG” switch 1 is set as “on”, the matrix will choose the higher definition HDMI 

display EDID. For example, One TV is 1080P, the other is 1080i. The “CONFIG” switch 1 is set as “OFF”, the 

selected EDID will be 1080i, When 2 HDMI display terminal choose different HDMI sources, the matrix just 

forward connected HDMI display terminal EDID to selected source, and don’t change anything. This function is 

to keep maximum compatibility and flexibility.

EDID call back function

All UTP extender output ports support the EDID call back function. UTP extender receivers will read EDID from 

display(s) then pass this EDID information to the matrix through the Cat5e/6 cable. The matrix will collect all 

connected displays EDID information and then do EDID dynamic selection. This function is automatic, no need 

to setup by customers. The intension function is to keep maximum compatibility 

Rs232 control port

The 4x4 matrix provide a RS232 series port for system configuration, firmware update, matrix control, please 

refer to assorted GUI help to know how to control the matrix.

Power over UTP cable

The 4x4 matrix has 4 UTP output ports that support power over the Cat5e/6 (POE) cable. This allows the 

receivers to get the power from the UTP output ports without DC adapters. Please note that UTP receivers 

must also support power over UTP (EVRX2006) and get the matched UTP extender receiver model for this 

function. This power over UTP function should be turned on when set “CONFIG” switch 2 to ON.

LAN port

The 4x4 matrix is also provided with a LAN port for TCP/IP control through a PC, control system,or  mobile 

device. The matrix utilizes an internal web server so that the PC or mobile phone can visit the matrix internal 

web page for control using a web browser. The web server allows access to matrix switching, EDID settings/

reading, DIP switch configuration etc.

Switch #  ON

OFF

   1

Choose the higher definition display terminal’s 

EDID forward to source

Choose the lower definition display 

terminal’s EDID forward to source

   2

Power over UTP function is ON

Power over UTP function is OF

   3

EDID dynamic selection will be done only with 

two sinks connected to same source

EDID dynamic selection will be done 

only 

   4

Local IR matrix is ON; Remote IR matrix is 

OFF

Local IR matrix is OFF; Remote IR 

matrix is ON

   5

Reserved

Reserved