VanEE 100H User Manual - 2. Controls
6
2. CONTROLS
These units are equipped with an integrated control, located on the
electrical compartment. Use the push-button (1) to control the unit.
The LED (2) will then show on which mode the unit is in.
NOTES: 1. The integrated control must be turned OFF to use an
optional main control.
2. If an optional auxiliary control is used, if activated, the
auxiliary control operation will override the optional
main control operation.
2.1 I
NTEGRATED
CONTROL
VD0278
1
2
VD0281
Refer to table below..
LED C
OLOR
R
ESULTS
AMBER
U
NIT
IS
ON
LOW
SPEED
GREEN
U
NIT
IS
ON
HIGH
SPEED
N
O
LIGHT
U
NIT
IS
OFF
OR
CONTROLLED
BY
A
MAIN
CONTROL
The unit boot sequence is similar to a personnal computer boot sequence. Each time the unit is
plugged after being unplugged, or after a power failure, the unit will perform a 30-second booting
sequence before starting to operate. During the booting sequence, the integrated control LED will
light GREEN or AMBER for 5 seconds, and then will shut off for 2 seconds. After that, the LED will
light RED for the rest of the booting sequence. During this RED light phase, the unit is checking and
resetting the motorized damper position. Once the motorized damper position completely set, the
RED light turns off and the booting sequence is done.
NOTE: No command will be taken until the unit is fully booted.
2.2 B
OOT
SEQUENCE
2.3 O
PTIONAL
M
AIN
AND
A
UXILIARY
C
ONTROLS
For more convenience, these units can also be controlled using an optional main control.
Only one main control can be connected per unit.
NOTE: If an optional auxiliary control is used, its activation will override the main control operation.
For more information about your unit controls, refer to the Main and auxiliary wall controls user
guide (included with your unit and also available at www.vanee.ca).
CAUTION
Turn off the integrated control and wait until its LED is turned off before using an
optional main wall control.