Vanguard 430447 Operating & Maintenance Instructions - Gauges

8

GAUGES

TYPICAL PANEL LIGHTS

 (If Equipped)

Temperature light

If temperature light comes on, engine is overheating. Check:

S

coolant level;

S

debris on radiator or any restriction to air flow.

See an Authorized Briggs & Stratton 3/LC Service Dealer if

necessary for operation repair.

WARNING LIGHTS (Typical)

Ignition light

The ignition light comes on when the starter switch is turned to

the ON position, and should be out while engine is running. If

ignition light goes out when starter switch is turned to the ON

position, check fuse or bulb.

Engine oil pressure light

The engine oil pressure light comes on when the starter

switch is turned to the ON position and should be out while

engine is running. If oil pressure light comes on while engine is

running, stop engine immediately. Check oil level or electrical

system.

Charge light

The charge light comes on when the starter switch is turned to

the ON position, but should be out while engine is running. If

charge light comes on while engine is running, check electrical

system.

STARTING

♦Use correct type of oil for expected starting

temperature. (See Oil.)

♦Remove external equipment/engine loads. (See

equipment operating instructions.)

♦Periodically remove any debris buildup from the

machine (See Maintenance.)

♦Open fuel shut-off valve, if equipped, before starting

engine.

♦Pull choke and move throttle to FAST position.

♦After engine has started, release key, which will return

to ON position.

♦Allow engine to warm up several seconds to several

minutes, depending on outside temperature.

♦Gradually open choke.

♦Use fresh gasoline, which has higher volatility to

improve starting.

♦For maximum performance and life, operate engine

with choke in OPEN and throttle in FAST.

STARTING IN COLD WEATHER:

CAUTION:

 Before starting engine for

the first time, charge battery as the

equipment manufacturer recommends.

Failure to do so, may cause damage to

the engine.

WARNING

• The manufacturer of equipment on which

this engine is installed specifies top speed at

which engine will be operated. DO NOT

EXCEED this speed.

WARNING

• Do not use pressurized starting fluids.

• Vapors are flammable.

• Keep hands and feet clear of rotating

machinery.