- DL manuals
- Vanguard
- Oven
- SBVBN
- Owner's Operation And Installation Manual
Vanguard SBVBN Owner's Operation And Installation Manual - Specifications
26
®
B-VENT FREESTANDING FIREPLACE
105500
SPECIFICATIONS
SBVBN(A)
SBVBP(A)
17,000-24,000 Btu/h
16,000-22,000 Btu/h
Gas Type
Natural
Propane/LP
Ignition
Piezo
Piezo
Manifold Pressure
3.5" w.c.
10.0" w.c.
Minimum Inlet Supply Pressure
4.5" w.c.
11.0" w.c.
Thermal Efficiency
70%
70%
Dimension, Inches/mm (HxWxD)
Fireplace*
27" x 26" x 25"
27" x 26" x 25"
685.8 x 660.4 x 635mm
685.8 x 660.4 x 635mm
Carton (Insert Only)
23" x 33" x 23"
23" x 33" x 23"
584.2 x 838.2 x 584.2mm
584.2 x 838.2 x 584.2mm
Weight, lbs/kg
Fireplace
70 lbs/31.8 kg
70 lbs/31.8 kg
Shipping
75 lbs/34 kg
75 lbs/34 kg
* When installed in Amity cast iron stove body (SCIVF Series and PSCIVF Series).
Summary of SBVBN
Page 1
B-vent freestanding fireplace heater ® owner’s operation and installation manual ® sbvbn(a), sbvbp(a) remote ready save this manual for future reference. For your safety what to do if you smell gas • do not try to light any appliance. • do not touch any electrical switch • do not use any phone in yo...
Page 2: Safety
2 ® b-vent freestanding fireplace 105500 safety information 1. This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases unless a certified kit is used. 2. For propane/lp fireplace, do not place propane/lp supply tan...
Page 3: Owner’S Manual
3 105500 owner’s manual p il o t lo hi off on on off auto product identification install and use fireplace with care. Follow all local codes. In the absence to local codes, use the current national fuel gas code ans z223.1, also known as nfpa 54* (usa) or the current can/cga-b149[.1 or .2] installat...
Page 4: Pre-Installation
4 ® b-vent freestanding fireplace 105500 location and space requirements determine the safest and most efficient lo- cation for your vanguard b-vent freestand- ing fireplace. Make sure that rafters and wall studs are not in the way of the venting system. Choose a location where the heat output is no...
Page 5: Owner’S Manual
5 105500 owner’s manual pallet wood bolted to bottom of stove body stove body assembly 1. Lift off corrugated box enclosing stove body crating. 2. Remove all screws fastening the wood frame enclosure. Spread wood frame open and lift away from plastic-bagged stove body. The bottom pieces of pallet wo...
Page 6: Freestanding
6 ® b-vent freestanding fireplace 105500 freestanding fireplace assembly continued figure 12 - attaching stove door step bolt door hinge threaded hole stove door stove bottom bolt shoulder adjusting nut bolt stop catch bolt door claw door figure 13 - catch bolt and door claw orientation 10. Attach s...
Page 7: Owner’S Manual
7 105500 owner’s manual warning: never touch the blower wheel while in operation. 7. Peel off the backing paper and stick the supplied wiring diagram decal on the inside of rear cover on right side oppo- site control. Warning: failure to position the parts in accordance with sup- plied diagrams or f...
Page 8: Venting
8 ® b-vent freestanding fireplace 105500 installation precautions consult local building codes before begin- ning the installation. Only a qualified ser- vice person should install venting system. The installer must follow these safety rules: • wear gloves and safety glasses for pro- tection • use e...
Page 9: Owner’S Manual
9 105500 owner’s manual figure 18 - typical b-vent installation warning: installation should only be made by qualified per- sons who are familiar with the safety procedures required for the installation of the product, who are equipped with the proper tools and testing instruments, and who have achi...
Page 10: Venting
10 ® b-vent freestanding fireplace 105500 venting installation continued checking vent capacity complete all gas piping, electrical, and vent connections. After adjusting the fireplace and lighting the main burners, allow a couple of minutes for warm-up. Hold a lighted match just under the rim of th...
Page 11: Owner’S Manual
11 105500 owner’s manual venting installation continued high altitude installation your vanguard b-vent freestanding fireplace heater has been aga tested and approved for elevations from 0-2000 feet and cga certi- fied for elevations from 0-4500 feet. When installing this fireplace at an eleva- tion...
Page 12: Fireplace
12 ® b-vent freestanding fireplace 105500 caution: use only new, black iron or steel pipe. Inter- nally-tinned copper tubing may be used in certain areas. Check your local codes. Use pipe of 1/2" diameter or greater to allow proper gas volume to fireplace. If pipe is too small, undue loss of pressur...
Page 13: Owner’S Manual
13 105500 owner’s manual pressure testing gas supply piping system test pressures in excess of 1/2 psig (3.5 kpa) 1. Disconnect fireplace and its individual manual shutoff valve from gas supply piping system. Pressures in excess of 1/2 psig (3.5 kpa) will damage fireplace gas regulator. 2. Cap off o...
Page 14: Fireplace
14 ® b-vent freestanding fireplace 105500 fireplace installation continued test pressures equal to or less than 1/2 psig (3.5 kpa) 1. Close manual shutoff valve (see fig- ure 28). 2. Pressurize supply piping system by ei- ther opening propane/lp supply tank valve for propane/lp gas fireplace or open...
Page 15: Owner’S Manual
15 105500 owner’s manual fireplace installation continued installing optional wall mounted thermostat - gwmt1 warning: installation must be done by a qualified installer familiar with low voltage wiring procedures. Warning: do not connect this thermostat to any electrical source! Electrical shock an...
Page 16: Fireplace
16 ® b-vent freestanding fireplace 105500 removing/replacing glass door caution: do not operate this fireplace with a broken glass door panel or without the glass door panel securely in place. For re- placement part information see replacement parts, page 25. 1. Remove 2 bolts from bottom of stove a...
Page 17: Owner’S Manual
17 105500 owner’s manual each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with freestanding fireplace. 1. Remove glass door. See removing/re- pl...
Page 18: Operating
18 ® b-vent freestanding fireplace 105500 to turn off gas to appliance 1. Open lower louver panel. 2a. Set selector switch in the “off” position. 2b. If using optional hand-held re- mote: set selector switch in the off position to prevent draining battery. 3. Turn off all electrical power to the app...
Page 19: Owner’S Manual
19 105500 owner’s manual 1. After lighting, let pilot flame burn for about one minute. Turn control knob on the control valve to on position. Turn flame adjustment knob any- where between hi and lo. Slide the selector switch to the remote posi- tion. Note: the burners may light if hand-held remote o...
Page 20: Inspecting
20 ® b-vent freestanding fireplace 105500 inspecting burners check pilot flame pattern and burner flame patterns often. Pilot assembly the pilot assembly is factory preset for the proper flame height. Alterations may have occurred during shipping and handling. Call a qualified service person to read...
Page 21: Owner’S Manual
21 105500 owner’s manual cleaning and maintenance warning: turn off fireplace and let cool before cleaning. Caution: you must keep con- trol areas, burners, and circulat- ing air passageways of fireplace clean. Inspect these areas of fire- place before each use. Have fire- place inspected yearly by ...
Page 22: Troubleshooting
22 ® b-vent freestanding fireplace 105500 troubleshooting note: all troubleshooting items are listed in order of operation. Warning: turn off heater and let cool before servicing. Only a qualified service person should service and repair heater. Caution: never use a wire, needle, or similar object t...
Page 23: Owner’S Manual
23 105500 owner’s manual observed problem burner does not light after pilot is lit delayed ignition burner burner backfiring during combustion slight smoke or odor during initial operation heater produces a whistling noise when burner is lit glass soots fireplace produces a clicking/ticking noise ju...
Page 24: Troubleshooting
24 ® b-vent freestanding fireplace 105500 troubleshooting continued warning: if you smell gas • shut off gas supply. • do not try to light any appliance. • do not touch any electrical switch; do not use any phone in your building. • immediately call your gas supplier from a neighbor’s phone. Follow ...
Page 25: Owner’S Manual
25 105500 owner’s manual service hints when gas pressure is too low: • pilot will not stay lit • burners will have delayed ignition • fireplace will not produce specified heat • propane/lp gas supply might be low (propane/lp units only) when gas quality is bad: • pilot will not stay lit • burners wi...
Page 26: Specifications
26 ® b-vent freestanding fireplace 105500 specifications sbvbn(a) sbvbp(a) 17,000-24,000 btu/h 16,000-22,000 btu/h gas type natural propane/lp ignition piezo piezo manifold pressure 3.5" w.C. 10.0" w.C. Minimum inlet supply pressure 4.5" w.C. 11.0" w.C. Thermal efficiency 70% 70% dimension, inches/m...
Page 27: Owner’S Manual
27 105500 owner’s manual accessories purchase these fireplace accessories from your local dealer. If they can not supply these accessories, call desa international’s sales department at 1-800-432-2382. For information. You can also write to the ad- dress listed on the back page of this manual. Wall ...
Page 28: Illustrated
28 ® b-vent freestanding fireplace 105500 illustrated parts breakdown sbvbn(a) sbvbp(a) lo h i p il o t off on 24 17 18 19 21 23 -1 23-4 23-2 23-3 26 27 4 22 9 4 1 10 11 8 2 4 4 7 28 13 14 15 16 20 20 25 5 29 3 12 6.
Page 29: Owner’S Manual
29 105500 owner’s manual key no. Part number description qty. 1 105479-01br firebox assembly 1 2 m11084-26 screw, hex 2 3 105484-01ck rear cover 1 4 m11084-39 screw, hex 12 5 103587-02ck switch plate 1 6 099998-01 fan switch 1 7 103284-04 wire harness 1 8 103284-06 wire harness 1 9 105812-01br baffl...
Page 30: Warranty Information
Limited warranty b-vent freestanding fireplace desa international warrants this product to be free from defects in materials and components for four (4) years from the date of first purchase, provided that the product has been properly installed, operated and maintained in accordance with all applic...