1. DL manuals
  2. Vanguard
  3. Gas Heater
  4. VN1800D
  5. Owner's Operation And Installation Manual

Vanguard VN1800D Owner's Operation And Installation Manual - Checking

Manual is about: INFRARED VENT-FREE NATURAL gas heater

Summary of VN1800D

  • Page 1

    ® models: vn1800d, vn1800ita, vn3000d, and vn2550ita save this manual for future reference. Warning: if the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury, or loss of life. — do not store or use gasoline or other flammable ...

  • Page 2: Contents

    2 101822 contents section page safety information ......................................................................... 2 product identification .................................................................... 4 local codes .......................................................................

  • Page 3: Safety

    3 101822 safety information continued warning icon g 001 warnings continued warning: any change to this heater or its controls can be dangerous. 1. This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases. 2. If you...

  • Page 4: Product

    4 101822 product identification local codes install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of national fuel gas code ansi z223.1, also known as nfpa 54*. *available from: american national standards institute, inc. 1430 broadway new yo...

  • Page 5: Fresh Air

    5 101822 fresh air for combustion and ventilation warning icon g 001 warning this heater must have fresh air for proper operation. If not, poor fuel combustion could result. Read the following instructions to insure proper fresh air for this and other fuel-burning appliances in your home. Today’s ho...

  • Page 6: Fresh Air

    6 101822 fresh air for combustion and ventilation continued determining fresh-air flow for heater location determining if you have a confined or unconfined space use this worksheet to determine if you have a confined or unconfined space. Space: includes the room in which you will install heater plus...

  • Page 7: Fresh Air

    7 101822 fresh air for combustion and ventilation continued or remove door into adjoining room, option 3 ventilation grills into adjoining room, option 2 12" 12" ventilation grills into adjoining room, option 1 warning icon g 001 warning if the area in which the heater may be operated is smaller tha...

  • Page 8: Fresh Air

    8 101822 fresh air for combustion and ventilation continued figure 3 - ventilation air from outdoors ventilation air from outdoors provide extra fresh air by using ventilation grills or ducts. You must provide two perma- nent openings: one within 12" of the ceiling and one within 12" of the floor. C...

  • Page 9: Installing

    9 101822 installing to wall notice a qualified service person must install heater. Follow all local codes. Check gas type use only natural gas. If your gas supply is not natural, do not install heater. Call dealer where you bought heater for proper type heater. Installation items before installing h...

  • Page 10: Installing

    10 101822 figure 5 - attaching thermostat sensing bulb for convenience and efficiency, install heater • where there is easy access for operation, inspection, and service • in coldest part of room an optional fan kit is available from your dealer. See accessories, page 31. If planning to use fan, loc...

  • Page 11: Installing

    11 101822 methods for attaching mounting bracket to wall only use last hole on each end of mounting bracket to attach bracket to wall. These two holes are 16 inches apart from their centers. Attach mounting bracket to wall in one of two ways. 1. Attaching to wall stud 2. Attaching to wall anchor att...

  • Page 12: Warning

    12 101822 marking screw locations 1. Tape mounting bracket to wall where heater will be located. Make sure mounting bracket is level. Models vn3000d and vn2550ita models vn1800d and vn1800ita figure 8 - mounting bracket clearances 2. Mark screw locations on wall (see figure 8). Note: only mark last ...

  • Page 13: Installing

    13 101822 4. For thin walls (1/2" or less), insert red key into wall anchor. Push red key to “pop” open anchor wings. Important: do not hammer key! For thick walls (over 1/2" thick) or solid walls, do not pop open wings. Figure 10 - popping open anchor wings for thin walls 5. Place mounting bracket ...

  • Page 14: Connecting

    14 101822 connecting to gas supply notice a qualified service person must connect heater to gas supply. Follow all local codes. Typical pipe diameters vn1800d or vn1800ita 3/8" or greater vn3000d or vn2550ita 1/2" or greater installation must include a manual shutoff valve, union, and plugged 1/8" n...

  • Page 15: Checking

    15 101822 important: hold pressure regulator with wrench when connecting it to gas piping and/or fittings. Tee joint reducer bushing to 1/8" npt 1/8" npt plug tap test gauge connection * sediment trap tee joint pipe nipple cap manual shutoff valve * 1/2" npt pipe nipple heater cabinet figure 13 - ga...

  • Page 16: Checking

    16 101822 on position off position figure 14 - manual shutoff valve manual shutoff valve open closed figure 15 - checking gas joints manual shutoff valve gas meter control valve location 4. Check all joints of gas supply piping system. Apply mixture of liquid soap and water to gas joints. Bubbles fo...

  • Page 17: Operating

    17 101822 operating heater models vn1800ita and vn2550ita for your safety read before lighting warning icon g 001 warning if you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must...

  • Page 18: Operating

    18 101822 lighting instructions 1. Stop! Read the safety information at the top of page 17. 2. Make sure manual shutoff valve is fully open. 3. Turn thermostat control knob on left side of heater clockwise clockwise to the off position. Operating heater models vn1800ita and vn2550ita continued ignit...

  • Page 19: Warning

    19 101822 1. Slightly press in plaque control knob on right side of heater and turn counterclockwise c-clockwise to the desired position. Important: release downward pressure while turning control knob. Control knob will lock at the desired position. 2. Turn thermostat control knob on left side of h...

  • Page 20: Operating

    20 101822 to turn off gas to appliance operating heater models vn1800ita and vn2550ita continued shutting off heater 1. Turn thermostat control knob clockwise clockwise to the off position. 2. Turn off all electric power to the appliance if service is to be performed. Shutting off burner only (pilot...

  • Page 21: Operating

    21 101822 high off low med pilot ign ignitor operating heater models vn1800d and vn3000d for your safety read before lighting lighting instructions 1. Stop! Read the safety information above. 2. Make sure manual shutoff valve is fully open. 3. Turn control knob clockwise clockwise to the off positio...

  • Page 22: Operating

    22 101822 4. Wait five minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, stop! Follow “b” in the safety information at the top of page 21. If you don’t smell gas, go to the next step. 5. Press in control knob. Note: you may be running this heater for the f...

  • Page 23: Operating

    23 101822 to select heating level figure 21 - burner patterns 1. Slightly press in control knob and turn counterclockwise c-clockwise to the low, medium, or high positions. Important: release downward pressure while turning control knob. Control knob will lock at the desired position. Operating heat...

  • Page 24: Inspecting

    24 101822 to turn off gas to appliance inspecting burner check pilot flame pattern and burner flame pattern often. Pilot flame pattern figure 22 shows a correct pilot flame pattern. Figure 23 shows an incorrect pilot flame pattern. The incorrect pilot flame is not touching the thermocouple. This wil...

  • Page 25: Inspecting

    25 101822 burner flame pattern figure 24 shows a correct burner flame pattern. Figure 25 shows an incorrect burner flame pattern. If burner flame pattern is incorrect, as shown in figure 25 • turn heater off (see to turn off gas to appliance, page 20 [models vn1800ita and vn2550ita] or page 24 [mode...

  • Page 26: Cleaning

    26 101822 cleaning and maintenance ods/pilot and burner orifice • use a vacuum cleaner, pressurized air, or small, soft bristled brush to clean. Cabinet air passageways • use a vacuum cleaner or pressurized air to clean. Exterior • use a soft cloth dampened with a mild soap and water mixture. Wipe t...

  • Page 27: Trouble-

    27 101822 observed problem when ignitor button is pressed in, there is a spark at ods/pilot but no ignition. Ods/pilot lights but flame goes out when control knob is released trouble- shooting continued remedy 1. Turn on gas supply or open manual shutoff valve. 2. Fully press in control knob while p...

  • Page 28: Trouble-

    28 101822 observed problem burner(s) does not light after ods/pilot is lit. Delayed ignition of burner(s) burner backfiring during combustion. Burner plaque(s) does not glow. Slight smoke or odor during initial opera- tion heater produces a clicking/ticking noise just after burner is lit or shut off...

  • Page 29: Warning

    29 101822 warning icon g 001 warning trouble- shooting continued if you smell gas • shut off gas supply. • do not try to light any appliance. • do not touch any electrical switch; do not use any phone in your building. • immediately call your gas supplier from a neighbor’s phone. Follow the gas supp...

  • Page 30: Technical

    30 101822 technical service you may have further questions about installation, operation, or troubleshooting. If so, contact desa international’s technical service department at 1-800-323- 5190. Vn1800ita vn2550ita btu (variable) 6,600-18,000 7,000-25,500 type gas natural only natural only ignition ...

  • Page 31: Replacement

    31 101822 fan kits - ga3100a and ga3200ta for all models. Provides better heat distribution. Makes heater more efficient. Complete installation and operating instructions included. Manually controlled - ga3100a. Includes on/off switch. Thermostatically controlled - ga32000ta. Includes three settings...

  • Page 32: Illustrated

    32 101822 1 2 3 11 6 4 8 5 6 7 12 23 9 10 24 14 17 16 21 18 22 20 19 15 13 illustrated parts breakdown model vn1800ita heater exploded view 23-19 23-18 ods/pilot assembly a b c 23-1 23-2 23-3 23-4 23-5 23-7 23-6 23-8 23-12 23-16 23-11 23-15 23-10 23-17 23-14 23-13 23-9 burner assembly.

  • Page 33: Parts List

    33 101822 parts list model vn1800ita this list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under replacement parts on page 31 of this manual. Key part no. Number description qty. 1 098304-01 screw, #10 x 3/8" 2 2 098742-13 front panel 1 3 09823...

  • Page 34: Illustrated

    34 101822 heater exploded view 1 2 3 11 6 4 8 5 6 7 12 23 9 10 24 14 17 16 21 18 22 20 19 15 13 illustrated parts breakdown model vn2550ita d c 23-1 23-2 23-3 23-8 23-16 23-17 23-11 b a 23-12 23-5 23-6 23-4 23-9 23-7 23-13 23-20 23-10 23-14 23-15 23-19 23-18 ods/pilot burner assembly.

  • Page 35: Parts List

    35 101822 parts list model vn2550ita this list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under replacement parts on page 31 of this manual. Key part no. Number description qty. 1 098304-01 screw, #10 x 3/8" 2 2 098742-14 front panel 1 3 09823...

  • Page 36: Illustrated

    36 101822 1 2 3 11 6 4 8 5 6 7 12 13 9 10 14 16 15 17 18 heater exploded view illustrated parts breakdown model vn1800d burner assembly a b c 13-1 13-2 13-3 13-10 13-4 13-5 13-6 13-7 13-18 13-8 13-9 13-14 13-13 13-12 13-11 13-15 13-17 13-16 ods/pilot.

  • Page 37: Parts List

    37 101822 parts list model vn1800d this list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under replacement parts on page 31 of this manual. Key part no. Number description qty. 1 098304-01 screw, #10 x 3/8" 2 2 098742-13 front panel 1 3 098238-...

  • Page 38: Illustrated

    38 101822 heater exploded view illustrated parts breakdown model vn3000d 13-17 13-16 ods/pilot burner assembly e d c 13-1 13-2 13-3 13-9 13-4 13-5 13-7 13-6 13-18 13-8 13-10 13-14 13-13 13-12 13-15 13-11 b a 1 2 3 11 6 13 4 8 5 6 7 12 18 9 10 14 15 16 17.

  • Page 39: Parts List

    39 101822 parts list model vn3000d this list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under replacement parts on page 31 of this manual. Key part no. Number description qty. 1 098304-01 screw, #10 x 3/8" 2 2 098742-14 front panel 1 3 098238-...

  • Page 40: Warranty Information

    Keep this warranty warranty information always specify model and serial numbers when communicating with the factory. We reserve the right to amend these specifications at any time without notice. The only warranty applicable is our standard written warranty. We make no other warranty, expressed or i...