Vantec NexStar TX Installation Manual
of
2
Enclosure for 3.5” SATA 6Gbps HDD
3. Note the SATA interface in the Tray and your
SATA drive.
5. Push the drive in the direction shown to fully
connect the SATA interface.
6. Secure two screws on each side to hold the drive
to the Tray.
1. Verify the package contents.
2. Remove the end cover and slide the Tray out.
4. Align Tray SATA interface with Drive SATA
interface and insert to connect the SATA
interface together.
7. Align the Tray guide rail to the housing guide
and slide the Tray into the housing.
Housing
Tray
8. Replace the end cover plate and secure with
two screws.