Vantec UGT-IH100 Installation Manual

Summary of UGT-IH100

  • Page 1

    1 multi-function front panel usb2.0/firewire 400/esata model no.: ugt-ih100 installation guide v1.01.

  • Page 2: Prescribed  Use

    2 prescribed use the ugt-ih100 is designed to be installed into the 3.5” or 5.25” plug-in unit of a computer housing and provides additional interfaces (usb2.0, firewire 400/esata). Furthermore, a 4port usb2.0 hub is integrated. This product complies with the applicable national and european specifi...

  • Page 3

    3 and all connected devices. Proceed with caution. Danger to life! Switch off the computer in which the product is to be installed and all connected devices. Disconnect all devices from the mains voltage and pull out the mains power supply plug! Just turning off at the on/off switch is not enough! •...

  • Page 4

    4 unit, loss of warranty! The red line is the +5v line of the 5-pole usb plug. It must be in accordance with the +5v connector of the usb port of the motherboard. • identify where the firewire port is on the motherboard, and then please connect the 6 pins. Please refer to the following diagram on ho...

  • Page 5: A) In General

    5 tips & notes a) in general • the integrated usb2.0-hub is automatically recognized and is integrated into the operating system. The required drivers are already components of the operating system. This is why there is no driver cd included and no separate driver installation is necessary. • which ...

  • Page 6: B) Usb2.0

    6 • with certain 1394 and usb2.0 devices (e.G. External hard discs) an icon with an arrow is displayed in the menu bar. Via this function the 1394 or usb2.0 device can be “separated” from the pc and therefore tell the pc to close open files. • partitioning and formatting hard discs which are connect...

  • Page 7: D) Esata

    7 other. For this reason, only one of the two connectors may be used at the same time! D) esata • contrary to usb/firewire, with esata it might be possible that an external hard disc is not recognized when connected during running operation. A new start might be necessary. Furthermore, the hard disc...

  • Page 8: Contact:

    8 information on how to receive warranty exchange or repair. Cosmetic defects and missing parts are not covered under this warranty. Please check the contents of the unit to make sure you received all parts. Also, check for any cosmetic flaws. If any parts are missing or if there are cosmetic defect...