Usb 3.0 4-port pci express card user manual model: ugt-pc341 all brand names and trademarks are properties of their respective owners www.Vantecusa.Com.
Ugt-pc341 page 2 contents: chapter 1: introduction ...................................................... 3 1.1 product introduction ................................................. 3 1.2 features ...................................................................... 4 1.3 system requirements ........
Ugt-pc341 page 3 chapter 1: introduction 1.1 product introduction super-speed usb 3.0 interface is the next revolution in i/o interconnect standards that will deliver the bandwidth and features required by pcs, consumer electronics and communications devices. With 10 times faster throughput than usb...
Ugt-pc341 page 4 1.2 features fully compliant with pci express base specification revision 2.0 single-lane (x1) pci express throughput rates up to 5 gbps compliant with universal serial bus 3.0 specification revision 1.0 supports simultaneous operation of multiple usb 3.0, usb 2.0 and usb 1.1 device...
Ugt-pc341 page 5 1.3 system requirements windows® xp/vista/7 (32/64 bit) one available pci express slot (recommend pci express 2.0) 1.4 package contents 1 x usb 3.0 4-port pci express card 1 x driver cd 1 x user manual 1 x sata to 4 pin molex power converter note: contents may vary depending on coun...
Ugt-pc341 page 6 the selected pcie slot on the motherboard. Push the board down firmly. 5. Replace the slot bracket’s holding screw to secure the card. 6. Replace the computer cover and reconnect the power cord. 2.2 driver installation 1. Insert the provided cd into your disk drive. 2. At the window...
Ugt-pc341 page 7 5. Select “via xhci host controller driver” and press “next”. Please review settings before install the driver, and click “next” to continue. 6. Click “next” to continue. Click “finish” to end of the driver installations steps..
Ugt-pc341 page 8 7. After driver installation is complete, your must restart your computer. Note: we do not provide usb 3.0 driver for mac and linux oss. 2.3 hardware verify 1. Click on the “device manager” tab in the windows control panel. Start > control panel > device manager.
Ugt-pc341 page 9 2. Entry “universal serial bus controllers” item, and you can read “via usb 2.0 hub”, “via usb 3.0 root hub” and “via usb extensible host controller” in the device manager. 2.4 driver uninstall 1. Click on the “programs and features” tab in the windows control panel. Start > control...
Ugt-pc341 page 10 2. Entry “uninstall or change a program” page, and double click “via platform device manager” to process driver uninstallation procedure. Chapter 3: troubleshooting tips if card and devices connected to the computer do not seem to be working properly, please perform below basic tro...
Ugt-pc341 page 11 steps: 1. Check that all cables are correct and securely connected. 2. Make sure usb device’s power is turned on. 3. Make sure the devices are getting enough power they require. 4. Make sure there is no problem with the card installation. Computer failed to start after inserting th...
Ugt-pc341 page 12 selecting “update driver” to renew usb driver. 3. This exclamation point usually means there is a resource conflict between this card and another card in your system. Please move the card to another available slot. Restart your computer. Windows will re-configure itself and re-assi...
