VAPamore MR-750 OTTIMO Instruction Book And Users Manual - page 4
FILLING & OPERATION
Fig.1
er
Do not ov
GO TO VAPAMORE.COM TO SEE THE MR-750 OTTIMO INSTRUCTIONAL VIDEO
(Fig.3)
Turn the controller knob clockwise to
increase the steam output and counter clockwise to
reduce the steam output.
Fig.2
Fig.3
Tank
fill cap
OUTPUT
+
_
Use steam controller
knob to adjust steam
output level
Status lights
On/off
switch
!
!
!
outlet. Allow steam cleaner to cool down before removing water tank cap. Unscrew the
water tank cap (Fig. 1) by pressing the cap down and simultaneously turning counter
Replace the water tank cap by pressing down on the cap and simultaneously turning it
Always use the dipstick to check the
or
Once the green light illuminates the steamer is ready for use. The green
clockwise. Check the water level with the supplied dipstick. Use the supplied funnel
Dip
stick
2800ml. If so drain excess water by removing the drain
plug to achieve desired water level.
!
Make sure steamer is completely cooled
the cap while the steamer is hot can cause scalding
and severe burns.
The dipstick has
4 marks, 100% - 2800ml, 75% - 2100ml, 50% -1400ml,
25% - 700ml. This allows options for working time and
heating wait time.
Fill chart for working and heatimg times (water amount -working time - heating time):
700ml - 30-45min. - 5-7 min. / 1400ml - 60-80 min. - 10-12min. / 2100ml - 90-120 min.
- 15-17min. / 2800ml - 150-180min. - 20-22min. (Measuring cup has a 700ml full mark)
clockwise. Make sure the cap is fully tight to prevent any steam from leaking out. If
cap fully.
“on” position. The red status light will illuminate when the power switch is on indicating
the water is heating. The green status light will illuminate indicating the water is fully
light will cycle on and off as the heater turns on and off during use. Continue to use the
steamer as you normally would as the green status light cycles on and off.
OPERATION
extension tube (use 1 to 2 tubes as desired). Ensure
Fig.1
Fig.2
Fig.3
The detail jet tool can be attached directly to the
steam gun or to any of the extension tubes. The jet
nozzle attachment is used with the accessory tool
adapter.
These tools are great for removing soap scum in the
bath, shower, and faucets. Also for cleaning tight
areas such as toilet seat hinges where high pressure
steam can reach and blow out dirt and debris. These
surface being cleaned. The steam temperature will
condense and cool within 1’’ of the tool tip. (Fig.4)
DETAIL JET TOOL / JET NOZZLE
GO TO VAPAMORE.COM TO SEE THE MR-750 OTTIMO INSTRUCTIONAL VIDEO
overhanging material under the clips located on each
walls and any hard surface. It can also be used to
sanitize, deodorize, kill allergens, bed bugs and dust
cleaning head to glide when using on carpet. (Fig.3)
Carpets
‘
’
CLICK
Floor head clicks
into extension
tubes
Micro
fiber pad
Fig.4
Detail jet tool
Jet nozzle on accessory tool adapter