Hvlp gravity feed spray gun kit instruction manual 19220 need help? Call our customer service hotline at 1-800-386-0191 for up-to-date product information, accessories and for a spanish version of this manual, please visit our website at: www.Titan-us.Com and click on the literature link or scan the...
After opening the carton, unpack your new product and related parts and accessories. Please inspect it carefully for any damage that may have occurred during transit. Please check it against the photograph on carton. If any parts are missing, please call factory customer service at 1-800-386-0191. D...
Save these instructions read and understand all instructions. Failure to follow all instructions included with this product could result in serious personal injury and/or property damage. Follow all local electrical and safety codes as well as in the united states, the national electrical codes (nec...
Before disassembly or removal of any part of gun or attached components, shut off air supply to gun, shut off air compressor, release pressure from spray gun by depressing trigger, and disconnect power source. Never assume system pressure is zero. To avoid creating an explosive atmoshphere, work onl...
Siphon feed cup hookup air pressure for atomization is controlled by the regulator on the air source. The amount of fluid is adjusted by the fluid control knob on the gun, the paint viscosity, and the air pressure. The siphon cup must be vented to the atmosphere. Pressure feed cup hookup air pressur...
1) thoroughly mix paint to be sprayed in accordance with the manufacturer’s instructions, adding thinner where necessary. 2) strain material through 60 to 90 mesh screen. 3) fill the paint cup about 3/4 full and attach to paint gun securely. 4) attach air supply to 1/4” nps inlet. Never point spray ...
Clean spray gun immediately after use. Paint and other spray materials dry quickly in the small passages of the gun rendering it unusable due to the difficulty of removing hardened paint from the passages inside the gun. Local codes may not allow the spraying of paint thinner or solvents. Use a gun ...
Shut off air supply to paint tank and release pressure in the tank. 1) open the vent on the paint tank. If using an external mix cap, loosen cap slightly. 2) reduce air pressure to 10 to 20 psi. Hold a wadded piece of cloth tightly over the air cap opening(s) and pull the trigger. Air will back up t...
Heavy top or bottom pattern horn holes plugged. Clean. Ream with non-metallic point. Obstruction on top or bottom of fluid tip. Clean. Cap and/or tip seat dirty. Clean. Excessive overspray. Gun too far from work surface. Adjust to proper distance. Improper stroking (arcing, gun motion too move at mo...
Item 19220 - parts breakdown guns 2 & 3 - production guns 18 no. Description no. Description no. Description 1 air adjustment valve 15 air manifold 29 fluid filter 2 gasket 16 tapered washer 30 fluid inlet fitting 3 air valve spring 17 air manifold spacer 31 gun body 4 air valve piston shaft 18 rete...
20 21 hvlp gravity feed spray gun tip size application guide tip size common applications for most fine finishing. Spot repairs and detail painting with primer, base coats, clear coats, single stages, low voc. 1.0 1.3 1.4 1.5 1.7 2.0 2.3 clear coats, base coats, water based coatings and single stage...
22 23 notes notes.
Star asia-usa, llc (hereinafter “seller”) warrants to the original purchaser only, that this product will be free from defects in material or workmanship for a period of 90 days from date of purchase for home domestic use. Warranty performance warranty coverage is conditioned upon purchaser furnishi...
