Vaporetto HANDY 3S09 Instructions Manual - page 12
VAPORETTO HANDY
11
even more inaccessible points, thanks to its
curved shape.
6B - Small round brush and 6C - Large round
brush:
suitable for removing caked dirt from
very narrow surfaces such as cooker burners,
roller shutters, joints between tiles, sanitary
fixtures, etc. It is possible to choose the most
suitable brush depending on the size of the
surface to be cleaned.
To connect accessories
6A-6B
or
6C
to the
lance (
6
), simply fit these accessories onto the
tip of the lance exerting a slight pressure (Fig.9).
TRANSPORT
One of the great advantages of this device is
that it can be carried anywhere, thanks to the
carrier handle (
H
) or the shoulder strap (13).
Some HOT water may leak out of the
accessories mixed with the steam, especially
when the tank has just been filled, while carrying
out the cleaning operations and as a
consequence of movement of the device.
CABLE-WINDER
When putting Vaporetto away, it is possible to
wind the power cable underneath it. To wind the
power cable, turn the black pin on the front of
the bottom part of the device and wind the
power cable as shown in Fig.10.
CARE OF YOUR APPLIANCE
•
Before attempting any maintenance
operation, make sure to always disconnect
the appliance from the electrical outlet.
• We recommend that the bristles of the brushes
are allowed to cool down in their normal
position after use, so as to avoid any mis-
shaping.
• To clean the body of the appliance, simply use
a moist cloth.
Regularly check the status of the red gasket lo-
cated in the moulded plug (
3
). If necessary, re-
place it with the appropriate spare part (
14
) as
below.
- Remove the broken / damaged red gasket.
- Insert the new one. Put it on the steam nozzle
and push it till its seat. See (fig. A)
- Lubricate the gasket with some oil.
Fig. A
ENGLISH
TROUBLESHOOTING
PROBLEM
SOLUTION
ON lamp (C) off
Check that the plug is correctly plugged into a suitable current socket.
Ensure that the appliance has been turned on using the ON/OFF switch
(B).
ON lamp (C) on but no steam
is delivered
Wait for the Steam pressure indicator lamp (D) to turn off (approx. 10
minutes). If the lamp (D) is off and steam is still not delivered, there is no
water in the boiler. Fill according to the instructions given in the manual.
The safety cap cannot be
unscrewed
Ensure the machine is off and disconnected from the
electrical outlet
and enable the steam control lever (4) on the steam gun (2) until the
steam flow ceases (paragraph “SAFETY CAP / SHORTAGE OF
WATER”)
If the problem persists, unscrew the cap at the same
time as applying gentle pressure with fingers to the cap
pin (see
fig. B)
Fig. B
VAPORETTO HANDY -NA- 4S09:FEV 1000-950.qxd
17/10/2012
11.23
Pagina 11