Varimixer V5A TEDDY Spare Part And Operation Manual - page 6
4
2
1
m
AInTEnAnCE
:
The mixerrequires no maintenance (motor and bearings for the
mechanical parts are greased for life).
Safety device:
Check the function of the safety device regularly:
•
Themotormust stop when the rotary knobs is in neutral
position
(see fig. 3B).
If the safety device does not function, do
not use the mixer. Contact your dealer.
l
IsT
of
Errors
AnD
possIblE
soluTIons
:
If the problem cannot be solved, contact
your dealer.
The mixer does not start:
Check that ...
•
Theupperpartofthemixerisinitsdownposition.
•
Themixerispluggedinandconnectedtopower.
•
Theelectricalpowersupplyiscorrect.
•
Thefuseinthecableplug
(fig.6, 1) has not been burned.
If the fuse is defective, it can be replaced by the extra fuse
(fig.6, 2) that is also available in the cable plug.
The mixer stops during work:
•
The mixer is overloaded due to too high speed or too
heavy loading. See the paragraph “Overloading”.
In case of power failure set the rotary but-
ton back to neutral position, and the mixer
can be started again.
The tool is stuck in the bayonet shaft:
Thisisnormallyduetoinsufficientcleaningordamagedholein
the tool:
•
Whenthetoolisstuck,donotforceitfree.Applyalittle
oil and let this work a couple of minutes.
•
Turnthetoolbackwardsandforwardsuntilitcanberemoved.
Unnormal noise:
Metallic noise ...
•
Thetoolisdistortedandhitsthebowl.
•
Thebowlhasbeendamagedorisnotinitsproperposition.
m
ounTInG
of
ACCEssorIEs
:
The mixer is equipped with an attachment hub with variable speed,
and with the possibility of attaching the following equipment:
•
Meatgrinder,suppliedwithmeattray,stomperandsetof
knives consisting of blade and plate 5/32”.
For further information regarding accesso-
ries, please see the special sheets following
the accessories.
The mixer must always be disconnected
before mounting or dismantling of the ac-
cessory.
Mounting of accessories (fig. 7):
•
Assembletheaccessory.
•
Stopthemixer.
•
TurnthecoverplateC away from the hole.
•
Whenmountingthepre-mountedaccessoryA, the shaft B
is inserted into the attachment drive D of the mixer.
•
ByturningtheaccessoryuntilthepinE is pointing towards
the slot G a correct clutch is obtained.
•
TheaccessoryispushedasfarintotheattachmenthubD
as possible. (The pin E must be in the slot G, then the shaft
of the accessory is in a correct clutch with the attachment
drive).
•
TheaccessoryisfastenedbyturningtheknobH clockwise.
Dismantling of accessories (fig. 7):
•
Stopthemixer.
•
TurntheknobH counterclockwise until the locking screw is
free of the hole F.
•
Takeouttheaccessoryoftheattachmenthub,dismantleand
clean it.
Fig. 7 Mounting of accessories.
r
ECommEnDED
spEEDs
for
ATTAChmEnT
hub
:
Fig. 6 Fuses in the cable plug.