Please refer to the diagram on page 2 1 remove nut (j) and shim washers (h) 2 pry off fork assembly (x). 3 remove special v-belt (a). 4 remove two 17mm bolts (v) 5 remove 4 bolts from motorplate (t). 6 on older model mixers with single phase motors,it may be necessary to disconnect the start & run c...
18 install special v-belt (a). 19 install fork assembly (x). 20 install washers (g) (h) and nut (j).Do not tighten nut. 21 start the mixer and tighten the nut (j). Do not overtighten! 22 on the front pulley set,the stud (k) on the varispeed collar (l) must be placed inside the lower fork (m),and on ...