VarTech Systems VT201CHC User Manual - Signal Connections
VT201CHC User Guide 150-060
1. Connect all cables to the station first. This would include the video adapter cable and the
original IR touch screen cable.
2. After connecting the cables between the LCD monitor and the station, plug the power cord
into the display.
3. Switch on the display power switch.
4. Reboot the station.
5. Your display should now operate showing the station video information.
Note: The displays are factory OSD adjusted for each configuration. However, additional OSD
adjustments may be required (See section 3).
⇒
20.1” LCD Monitor
⇒
Video adapter cable (HD15 to DB
9)
⇒
Accessory Kit: OSD Membrane Kit; Chassis Brackets; Power Cord; a HD15 to DB9 Video
Adapter Cable.
⇒
Users Guide (Printed or on CD)
2.2
Unpacking and setting up your display
Your LCD monitor package will consist of the basic components listed below. Depending on the
display configuration, additional components are supplied.
2.3
What is included with your display
2.4
Connecting the Display
2.5
Signal Connections
To avoid irregular operation and /or damage to the display, please insure correct video is being
supplied as shown on the following page.