Varytec Easy Move XS HP Wash User Manual - 2. Preface
4 / 14
Warning! Verify that the voltage select switch on your unit matches the line voltage
applied. Damage to your fixture may result if the line voltage applied does not match the
voltage indicated on the voltage selector switch. All fixtures must be connected to circuits
with a suitable Earth ground.
Important:
Damages caused by the disregard of this user manual are not subject to
warranty. The dealer will not accept liability for any resulting defects or
problems. Make sure the electrical connection is carried out by qualified
personnel. All electrical and mechanical connections have to be carried out
according to the European safety standards.
2. Preface
2.1. Packing list
Product name
Quantity
Flat Par Light
1 pcs
Power -line
1 pcs
User Manual
1 pcs
2.2. Unpacking instructions
Once receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are
presented, and have been received in a good condition. Notify the shipper immediately and retain
packing material for inspection if any parts appear damaged from shipping or the carton itself shows,
sign of mishandling. Save the carton and all packing materials. In the event that a fixture must be
returned to the factory, it is important that the fixture be returned in the original factory box and
packing.
2.3. AC Power
To determine the power requirements for a particular fixture, see the label affixed to the back plate of
the fixture or refer to the fixtures specifications chart. A fixture listed current rating is its average
current draw under normal conditions. All fixtures must be directly powered off a switched circuit and
cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer source
voltage matches the fixtures requirement. Check the fixture or device carefully to make sure that if a
voltage selection switch exists that it sets to the correct line voltage you will use.