Vasco Digipass 310 User Manual
User Manual for Digipass 310
Digipass is an electronic device used for the generation of electronic signatures and authorisation
for Internet banking.
Digipass device is switched on by pressing and holding the ON/OFF button. Digipass is switched
off by repeatedly pressing and holding the button. The device switches off by itself after 30-40 sec,
if no actions are taken.
Entry of the initial IPIN code and its change to client’s PIN code
Before using the authorisation device Digipass, it is necessary to change the initial IPIN code to the
PIN code set by a client. By default, Digipass device has been assigned a 5-digit IPIN code —
00000.
Digipass device has four special buttons: “←” “→”, “OK”, “BACK”.
The
“←” and
“→” buttons are used for navigation.
The “OK” button is used to switch the device on or off, as well as to confirm entered data.
The “BACK” button is used to delete incorrectly entered symbols.
Attention!!! During the execution of the above procedure, the device MUST NOT be switched
off until initialisation has been completed. Otherwise the device will be locked!
To change the IPIN code, the following actions should be taken
No. Action
Display message
Comment
1
Press the ON/OFF button to
switch the device on (hold it
for a couple of seconds)
Welcome to LPB
Digipass 310
A short welcome message from the bank.
2
The device requests the
initial IPIN code
INITIAL PIN
_ _ _ _ _
The initial code for Digipass device is 00000.
3
Enter the initial IPIN code
INITIAL PIN *****
4
Press the OK button
PIN OK
Confirmation that IPIN has been entered
correctly.
5
The device requests a new
PIN code (a 5-digit code of
your choosing)
NEW PIN
_ _ _ _ _
Enter your 5-digit PIN code. The code may
consist of any digits, but all 5 digits cannot be
the same or consist of 5 succeeding digits in
ascending order.
6
Enter your new PIN code
NEW PIN *****
7
Press the OK button
CONFIRM _ _ _ _ _
CONFIRM ******
Enter your new PIN code again for confirmation.
Press the OK button.
WEAK PIN
The PIN you have entered offers weak
protection. Press the OK button and enter a
different PIN code.
8
Press the OK button
PIN CHANGED
The initial IPIN code has been successfully
changed to the PIN code entered by client.
1