Vaux Electronics Lattis 1600 Series Owner's Manual - page 11
11
Remote Control Setup Commands (shift-pause-x):
Note: The earlier RC-8-IR remote control may also be used to set this adjustment.
* shift-pause-1
Zone-Initial-Volume-To-Current
zone 1-90, also ack/nak flash
* shift-pause-2 Zone-Mute-Volume-To-Current
zone 1-90, also ack/nak flash
* shift-pause-3 Zone-Min-Volume-To-Current
zone 1-90, also ack/nak flash
* shift-pause-4 Zone-Max-Volume-To-Current
zone 1-90, also ack/nak flash
* shift-pause-5 Zone-Previous-Volume-Flag-Off
zone 1-90, also ack/nak flash
* shift-pause-6 Zone-Previous-Volume-Flag-On
zone 1-90, also ack/nak flash
* shift-pause-7 Zone-Current-Volume-To-0dB
zone 1-90, also S50 mssg and ack/nak flash
shift-pause-8 Zone-Restore-Factory-Settings
zone 1-90, also ack/nak flash
shift-pause-9 Restore-All-Factory-Settings
light-bar, also sends S190 mssg
(* zone must be on and unmuted to change)
Examples (first set RC-16 to desired zone, then select a source):
1) to configure a zone's maximum volume level (power amp has gain adjust):
- turn power amplifier's gain down (to perhaps 30 %)
- adjust volume, using remote control, to maximum
- adjust power amplifier's gain to loudest acceptable volume level
2) to configure a zone's maximum volume level (power amp has no gain adjust):
- adjust volume, using remote control, to desired level
- press shift-pause-4 to store this volume as the Maximum-Level
3) to configure a zone for a fixed initial (turn-on) volume level:
- press shift-pause-5 to turn Previous-Volume-Flag off
- adjust volume to desired level
- press shift-pause-1 to store this volume as the Initial-Level
4) to configure a zone for passthrough volume level (fixed 0 dB):
- press shift-pause-5 to turn Previous-Volume-Flag off
- press shift-pause-7 to set volume to 0 dB
- press shift-pause-1 to store this volume as the Initial-Level
5) to configure a zone for using Previous-Volume as initial level:
- press shift-pause-6 to turn Previous-Volume-Flag on
6) to configure a zone for a desired mute level:
- adjust volume to desired level
- press shift-pause-2 to store this volume as the Mute-Level
7) to configure a zone for a desired minimum volume level:
- adjust volume to desired level
- press shift-pause-3 to store this volume as the Minimum-Level
8) to restore a zone's programmable parameters to factory settings:
- press shift-pause-8, and reset a zone's initial/mute/min/max/tapers...
9) to restore all switcher programmable parameters to factory settings (careful!):
- press shift-pause-9, and reset all zones, base-zone, erase ir-codes...