Vax bliss Bagged Cylinder User Manual - page 3
4
5
www.vax.com.au
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
Operation
Operation
Keep your Vax like new
Operating the appliance
Assembling your vacuum cleaner
1. Attaching the Flexible Hose into the vacuum. (Pict. 1)
2. Connect the flexible hose into the air intake duct; push in until you hear a “click”, indicating it is in its locked position.
IMPORTANT: The condition of the filters affects the performance of
your machine. Please check and clean filters periodically (depending
on the level of use). For full cleaning instructions, see Maintenance.
IMPORTANT: Do not use the vacuum cleaner without all of the
filters in place.
3. Push the tube into the curved hose extension, (Pict. 2). Fit the tube into the Floor Brush by pushing. (Pict. 3) Adjust the tube to
the desired length. (Pict. 2- 3)
Once all attachments are in place
1. Unwind a sufficient length of cable and insert the plug into the wall outlet.
2. A yellow mark on the power cord shows the ideal cable length, (Pict. 4).
3. Do not pull the power cord beyond the red mark, (Pict. 5).
4. Insert the power plug into the wall outlet.
5. Press the power on/off button located on the unit to turn the vacuum cleaner “on”, (Pict. 6).
To rewind the power cord:
1. Press the Cord Rewind Button with one hand and guide the power cord with the other hand to ensure that it does not whip
around causing damage or injury, (Pict. 7).
To adjust the suction:
1. Slide the suction control button on the suction handle to increase or reduce the suction. (Pict. 8).