Vax DynamoPower U85-DP-Be Getting Started Manual - What To Do If It Goes Wrong
What to do if it goes wrong
• Check the ‘This pack contains’ panel on the box to make sure the part
is included with your machine.
• There may be a blockage in the hose. Please remove the hose from the
vacuum cleaner, check and clear any blockages.
• Empty the dirt container and clean filters.
Go to the ‘Taking care of your machine’.
• The brushbar may not be turning. Go to my brushbar isn’t turning below.
• If the accessory/tool will not pick up, check and clear any blockages.
• The plug may not be fully pushed into the electrical socket.
• Check the fuse in the plug if this needs replacing, always replace with
a British 13amp fuse.
• The motor thermostat may have tripped. If this has happened, unplug
the vacuum cleaner. Remove and empty the dirt container and check
the hose for blockages.
• Clean the filters and allow the vacuum cleaner to cool for
approximately 1 hour (if you have washed the filters you will need to
wait 24 hours for the filters to fully dry before putting them back into
the vacuum cleaner).
• The brushbar may be clogged, check the brushbar and clear any hair
or debris. Go to ‘Let’s talk technical’.
• The belt may be broken. Go to ‘Let’s talk technical’.
Solution
Problem
IMPORTANT: To reduce the risk of personal injury, unplug the vacuum before performing maintenance
/troubleshooting checks.
There is an
accessory missing
Why does my
vacuum cleaner
have no power?
Why won’t the vacuum
cleaner pick up?
My brushbar
isn’t turning