Vax Energise Tempo U86-E1e Series User Manual - Looking After Your Machine
10
vax.co.uk
9
Looking After Your Machine
Clearing blockages
Hose blockages
The flexible hose may be disconnected from the
vacuum cleaner. Carefully remove any blockages found
and reconnect the hose securely.
Accessory blockages
Remove accessory from the hose. Carefully remove
the blockage and return to the cleaner.
Turn the lid of the dirt container
anticlockwise to remove the lid.
Then turn the separator clockwise
to remove filter from the dirt
container lid.
Cleaning the HEPA filter
Remove the HEPA central filter
from the separator.
Tap the HEPA central filter against a
bin to release dirt and then return to
the unit.
IMPORTANT: It is very important to keep the filters clean to maintain maximum performance of the vacuum.
Vax recommend that your filters should be cleaned at least every 3 months (depending on the level of use).
Do not use detergent to clean the filters.
TurboTool blockages
Locking ring
Tabs
Locking ring
Tabs
Slide off the locking ring.
To re-assemble the TurboTool,
ensure that the tabs are engaged
and pivot the lower housing
closed. Slip the locking ring over
the neck of the TurboTool and into
the groove to secure.
Detach lower housing and remove
blockage.
Locking ring
Tabs
Looking After Your Machine
Replacing the belt
Remove the brushbar cover from
the base of the unit.
Lift the brush bar out of the base of
the unit. Next, remove the belt from
the brushbar and from the motor
spindle towards the rear of the floor
head. Replace the belt.
Turn unit over and remove the
six screws using a crosshead
screwdriver as indicated by arrows.