Vax Floormate V-120 Instruction Manual - page 4
www.vax.co.uk
4
preparation
3. Preparing the Cleaner
Installing Brushed and Nozzle
To install brushes, place handle in upright position. Tilt
cleaner back so that it rests on the floor. Align post (A) on
brush block with hole (B) on bottom of cleaner. Turn
brushes slightly until post fits easily into hole (Fig.3/1).
Press brush assembly firmly to snap into place (Fig.3/2).
To install nozzle, make sure latches (A) are out. Align
middle section of nozzle with opening on cleaner. Remove
cardboard packing insert from squeegee area on underside
of nozzle (Fig.3/3).
While holding nozzle in place, slide latches inward to lock in
place (Fig.3/4).
Unfold Handle
Raise upper handle to upright position until it locks in place
(Fig.3/5).
To lower handle, press upper handle release button and
fold handle to storage position (Fig.3/6).
Fig.3/1
A
B
Fig.3/2
Fig.3/5
Fig.3/6
Fig.3/4
Fig.3/3
A
A
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 4