Vax Kruz K-020 Instruction Manual - page 4
3.HowtoAssemble
Line up nozzle with main body and firmly push
nozzle onto body of unit until nozzle locks into
place (Fig.3/1).
NOTE: To remove, push release button
and pull the nozzle away from the body
of the unit.
4
5
6.DirtContainer&Filter:
Removal&Replacement
IMPORTANT: For best results,
clean after each use.
NOTE: For best results replace the filter
at least every six months.
Dirt Container Removal
Depress the dirt cup release button located
above the dirt cup and pull away from the
body of the unit (Fig.6/1).
4.Charging
NOTE: Use only the charger supplied by
the manufacturer to recharge.
CHARGE 24 HOURS BEFORE FIRST USE.
For best results, return the Stick Vac to
the charging base after every use.
Connect wall charger to the outlet (Fig.4/1).
Fig.4/1
Fig.4/2
Place Stick Vac on the charger base. The
indicator light will come on to indicate that the
Stick Vac is charging. Unit will be charged in
16- 24 hours. The light will not change colour
or shut off when the unit is fully charged
(Fig.4/2).
NOTE: The power button must be in the
off position for the Stick Vac to charge.
5.HowtoOperate
Push the button on the top of the upper handle
to turn the cleaner on and off (Fig.5/1).
Grasp filter adaptor and pull out of dirt cup
(Fig.6/2).
Fig.3/1
ASSEMBLY
Fig.3/2
Fasten three (3)
secure the upper
Fig.3/3
Nozzle
release
button
Fig.5/1
Fig.5/2
Fig.5/3
Fig.6/1
TER
Fig.6/2
Slide upper handle onto post on main body
(Fig.3/2).
NOTE: If unit turns on when assembling
handle to unit, depress power button &
continue assembly.
Fasten three (3) screws to secure the upper
handle to the main body (Fig.3/3).
The main body of the cleaner can rotate at
the nozzle offering greater manoeuvrability
(Fig.5/2).
In addition to a front to back motion, the
cleaner can also vacuum side to side
(Fig.5/3).
NOTE: This can be used for effective
edge cleaning.
NOTE: This filter is NOT washable.