1. DL manuals
  2. Vax
  3. Washer
  4. Rapide V-025
  5. Instructions For Use Manual

Vax Rapide V-025 Instructions For Use Manual

Summary of Rapide V-025

  • Page 1

    Save these instructions for future reference model v-025 instructions for use please register your warranty . Send in your completed warranty car d. If you requir e any further assistance or advice about any vax please call v axcare on 1300 364040 (australia - cost of a local call) and 0800800 900 (...

  • Page 2: Other Vax Appliances

    Read all instructions before using your vax rapide carpet washer • this is not a dry vacuum cleaner. Carpets should be thoroughly vacuumed prior to washing with the vax rapide. • do not leave the appliance when plugged in. Unplug it from socket when not in use. • to prevent electric shock do not use...

  • Page 3

    Cleaner won’t run vacuum won’t pick up/ loss of suction dust escaping from the vacuum cleaner won’t dispense solution • power cord not firmly pushed into a mains socket. • blown house fuse or tripped circuit breaker. • dirty water tank is full. • dirty water tank is not installed properly. • solutio...

  • Page 4

    Stand the base in the upright position. Assemble the mid section onto the base, taking care not to trap internal mains wire. Insert the three nuts into the recesses located on the left and right sides and the middle of the back of the base. While holding the nuts in place insert screws through the f...

  • Page 5

    Grasp brushroll with one hand, using the other hand to keep ten- sion on the the belt while removing. Lift up while your pulling it out. Slide the belt off the the motor shaft and dispose. Belt or brush removal and replacement 12 important: turn off when emptying and filling the reservoir. Grasp the...

  • Page 6

    Fill the measuring cap 3 times with vax aaa carpet cleaning solution and pour into the reservoir. Note: the cleaning solution supplied with your machine is vax aaa carpet cleaner. When replenishing this item, please use vax carpet cleaner which is available in 1 litre bottles from your vax stockist ...

  • Page 7

    Lift the front of the carpet cleaner base off the carpet with one hand. Grasp the handle and hook the front of the dirty water cleaner into the base, making sure that the front of the dirty water tank is resting on the base. The dirty water tank has three tabs on the underside which must latch on to...

  • Page 8

    You will hear a distinct change in the noise coming from your cleaner when the tank is full and needs emptying. Important: unplug your cleaner before emptying the dirty water tank. Grasp the top of the dirty water tank handle and press the release latch. Grasp the handle and pull up out of the base....