Vax Steam Clean Multi S85-CM Let's Get Started - Using Your Machine
Remove floorhead and handle
and place steamer on flat
surface. Twist water tank
cap anti clockwise and lift
to remove.
Correct
Incorrect
Do not fill directly from tap
or over sink. Keep steamer
on flat surface. Use the
measuring jug and fill the
tank with 330ml (2 x 165ml)
of water.
Replace cap, align tabs
and twist clockwise
to tighten.
IMPORTANT
• Never turn the steamer over when water is in the tank, as some water may leak through the air valve.
It is normal for the water tube to make a rattling sound inside the water tank during use.
Filling water tank
Cleaning hard floors
Place the microfibre pad on the
floor white side facing up. Place the
floorhead onto microfibre pad making
sure the microfibre pad covers the
entire floorhead.
Plug into mains, turn dial to ‘ON’;
the red light will illuminate to indicate power
on. The steamer will be ready after
approximately 30 seconds. There will be no
sounds for the first 30 seconds whilst it is
heating up.
To steam your floors twist the steam
control dial to desired setting. Steam
is activated automatically. Take
care when changing settings
during cleaning.
Place foot onto the floorhead and
pull handle backwards to recline.
Turn dial to ‘OFF’ position and allow
steamer to cool, the amber light will
switch off. Hold corner of pad down with
your foot and lift steamer to peel away.
IMPORTANT
• Never use the steamer without a microfibre cleaning pad attached to the floorhead.
• Never leave the steamer on one spot for an extended period of time or with a damp or wet microfibre pad attached as this
may damage the floor surface.
Move the steamer slowly backwards
and forwards across the floor paying
particular attention to high traffic areas.
Using your machine
TIP
The water tank cap
has lock and unlock
padlock symbols.