Uk service & help - vax care 0870 6061248 monday to frday 9.00am to 5.00pm. An answer phone is available out of these hours. If you have queries or concerns about using your vax, call the helpline. Calls are charged at the uk national rate. Please make a note of the serial number and model number of...
2 1. Hanging loop 2. On/off switch 3. Upper handle 4. Lower handle 5. Dust canister release button 6. See-through dust canister 7. Dry cloth head 8. Cleaner nozzle 9. Dry cloths 10. Charger 11. Charging indicator 12. Charger input parts checklist 11 1 2 3 4 5 6 7 8 10 9 12.
Putting your cleaner together insert the lower handle into the body of the unit and firmly push in until it locks into place. Be sure to line up the 2 notches to help guide the lower handle into the body properly. Insert the upper handle into the lower handle of the unit and firmly push into place. ...
4 charging storage note: only use the charger supplied. Charge 24 hours before first use. Connect the charger to a wall socket. Plug the charger end into the back of the unit. Use the storage hook to hang the cleaner up. Note: hang in a place convenient for charging. 1 2 1.
5 operating the vacuum cleaner for advice on electrostatic dry cloths, please call vax care on 0870 6061248. Note: this product is intended for dry pick up only. Do not attempt to vacuum up any liquids with this cleaner. Lift the vacuum nozzle. It should lock into position. Place one electrostatic c...
6 operating the vacuum cleaner use the dry electrostatic cloth to pick up fine debris like dirt, dust and pet hair. Use the vacuum to suck up any left-over debris. For best results, replace the dry cloth as needed. To turn the vacuum on: hold down the on/off button located on the handle. Release the...
Dust canister and filter important: for best results, clean the filter after each use. For advice on filter replacement, please call vax care on 0870 6061248. Removing the dust canister press the dust canister release button located above the container on the body of the unit. Tip the dust canister ...
8 dust canister and filter replacing the dust canister return the filter to the dust canister. Re-attach by aligning the tab on the dust canister with the slot on the body of the unit. Tilt and push the dust canister until it locks into place. 4 5 6 slot tab.
Troubleshooting problem cleaner won’t run cleaner won’t pick-up/loss of suction dust escaping from cleaner possible reasons 1. Battery not charged. 2. Handle is not pushed into housing. 3. Battery dead - won’t hold a charge. 4. Needs service. 1. Dust canister is full. 2. Filter is dirty. 3. Battery ...
Safety • use only dry dusting cloths. Do not use wet cloths. • to prevent electric shock, do not use outdoors or on wet surfaces. • do not charge the unit outdoors. • not to be used as a toy. Close attention is necessary when used by or near children. • use only as described in this user guide. • us...
11 (this page has been left intentionally blank).
Eec statement of compliance manufacturer/eec importer: vax limited, hereby on our own responsibility declare that the product sweeper vac is manufactured in compliance with the following: safety: 72/23/eec low voltage directive as modified by 93/68/eec emc: 89/336/eec electromagnetic compatibility d...
