Easy guide please r ead car efully befor e using your cleaner . Always fully extend mains cable befor e use. V -056tt cylinder range v-056tt d1 10/25/05 3:46 pm page 1.
Par ts checklist parts accessories optional accessories 1) carry handle 9) dusting brush 14) *t urbobrush 2) on/of f button 10) upholstery tool (* log on to www .Vax.Co.Uk to buy on line) 3) cor d r ewind button 11) cr evice tool 4) hose connection socket 12) combination floor head 5) dust container...
Assembling the cleaner 2 1 fig. 1 to attach the flexible hose to the vacuum cleaner , push the connecting end of the flexible hose into the hose connection socket on the vacuum cleaner by pr essing the two buttons on either side of the hose connection. Fig. 2 the telescopic extension tubes can be le...
Assembling the easy-reach tool system y our v ax cylinder is equipped with easily-accessible tool storage. T o assemble this, please follow these instructions. Fig. 3 the tool storage system fixing bracket is alr eady in place on the extension t ube. Insert the holding tubes as shown until the tubes...
5 6 adjusting the combination head for carpets & hard floors y our v ax cylinder comes equipped with a combination floor head that can be used on carpets and har d floors. Flick the r ocker switch to the appr opriate position as detailed below . Fig. 5 har d floor position (tiles, par quet floors, e...
How to use your vax cylinder note: fully extend the mains cable and plug it into a standar d domestic outlet. Fig. 7 p ress the on/of f button to start the vacuum cleaner . T o stop it, pr ess the on/of f button again. Fig. 8 p ress the cable r ewind button to r ecoil the power lead. Fig. 9 the hose...
Carr y handle release/how to store fig. 10 the carry handle can be ‘locked’ secur ely by pushing the handle down until it lies flush with the machine body (fig.10); you will hear the handle click into place. T o r elease the handle, slide the r elease catch (fig.10a) towar ds the hose end of the mac...
How to empt y the dust container fig. 13 t u rn o ff the cleaner and unplug. Pr ess the two top cover r elease buttons and raise the top cover to access the dust container . Fig. 14&15 remove the dust container by lifting it out as shown. Fig. 16 pr ess the r elease button over a rubbish bin so that...
17 to clean or change the filters main filter - this filter should be cleaned fr equently and washed occasionally . Fig. 17 the cyclone jug filter is located in the top of the dust container . Remove the filter and tap against the side of a rubbish bin to r emove excess dust. The filter can be washe...
Troubleshooting accessories pr oblem possible cause possible solution cleaner won’ t run. • power cor d not firmly pushed into mains socket. • plug cor d in firmly to power outlet. • blown fuse or tripped cir cuit br eaker . • check fuse/br eaker . Replace fuse or r eset br eaker . Cleaner won’ t pi...
Safet y • for indoor use only . • do not leave the appliance unattended when plugged in. Unplug it fr om socket when not in use. • t o pr event electric shock do not use outdoors or on wet surfaces. • not to be used as a toy . Close supervision is necessary when used by or near childr en or the infi...
Eec st a tement of compliance manufactur er/eec importer: v ax limited, her eby on our own r esponsibility declar e that the pr oducts v -056 tt ar e manufactur ed in compliance with the following: safety: 73/23/eec low v oltage dir ective, as modified by 93/68/eec emc: 89/336/eec electr omagnetic c...
