Vax U86-PM Series Instruction Manual - Warning

Unit must be in the upright 

position to change the floor mode

WARNING

Before you begin cleaning

•  Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or 

removing and emptying the dirt container.

•  The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the 

thermostat will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug 

from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the 

vacuum cleaner to cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to 

fully dry before putting back into the vacuum machine) 

•  For best cleaning results filters require cleaning at least every 3 months.

•  If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.

Push the on/off switch to 

turn machine on

Place your foot gently on the 

floorhead and pull the handle 

backwards to recline the machine 

Getting started

Using your machine

Remove hose end from 

the floorhead

Choose an accessory*

Attach accessory  

to hose end/extension 

tube/adapter

Push the quick release 

cord hook to one side to 

release the power cord

Turn the height adjuster 

dial backwards for the 

carpet setting

Turn the height adjuster dial for-

wards for the hard floor setting, 

the floorhead will tilt forward

*Not applicable for all models

Using accessories

Attach extension tube/

adapter if necessary to 

hose end