Vax U87-AA-B User Manual - Vax.Co.Uk
vax.co.uk
7
Looking After Your Machine –
Removing Blockages
Re-setting the brushbar
Removing debris from the brushbar
A
RED
flashing light will
indicate a jammed brushbar.
To reset press the
RED
button in the middle of
the floorhead.
A
GREEN
flashing light
indicates no blockages in
the brushbar.
Place the vacuum cleaner on
the floor upside down and
remove the screw on the
back of the brushbar cover.
Unclip both clips on the
brushbar cover.
Remove the brushbar cover
and remove and debris, hair
and dirt from the brushbar
and belt.
If the light continues to flash red after resetting, the brushbar may still be blocked. Using a pair of scissors, cut through any
threads or hairs caught around the brushbar. To access brushbar:
Press the brushbar reset
button again to ensure the
blockage is fully cleared.
IMPORTANT: If the air inlet, hose or telescopic tube is blocked, switch off the vacuum cleaner and remove the
blockage(s) before re-starting the vacuum cleaner.
NOTE: Brushbar and belt are not removable