Vax U91-P3 Series Instruction Manual - page 7
7
Vax Careline
0870 606 1248
clearing blockages / troubleshooting
8. Clearing Blockages
WARNING: To reduce the risk of injury from
moving parts, unplug before servicing.
Clearing Blockages from the TurboTool
1. Turn the TurboTool/Power Brush over and slide off the
O-ring (Fig.8/1).
2. Pivot lowering housing and remove clog (Fig.8/2).
3. To re-assemble, be sure that the tabs are engaged. Pivot
the lower housing closed. Slip the O-ring into the groove at
the neck of the TurboTool/Power Brush to complete
reassumbly (Fig.8/3).
9. Troubleshooting
WARNING: To reduce the risk of personal injury,
unplug the vacuum cleaner before performing
maintenance or troubleshooting checks.
PROBLEM: Vacuum cleaner won't run
Cause:
Not properly plugged into electrical outlet.
Solution: Plug in firmly.
Cause:
Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
Cause:
Thermal cut out.
Solution: Refer to page 3 for information.
PROBLEM: Cleaner won’t pick up/loss of suction.
Cause:
Lower hose not connected properly.
Solution: Refer to page 4 for fitting information.
Cause:
Dirt container not installed correctly, or full.
Solution: Review dirt container replacement.
Cause:
Broken or worn belt.
Solution: Replace the belt.
Cause:
Clogged filters.
Solution: Remove, clean and replace filters.
Cause:
Nozzle / hose or hose inlet is clogged.
Solution: Remove nozzle/hose and obstruction.
PROBLEM: Dust escaping from the vacuum cleaner.
Cause:
Dirt container full.
Solution: Empty dirt container.
Cause:
Dirt container not installed correctly.
Solution: Review dirt container replacement.
Cause:
Hose not installed properly.
Solution: Review vacuum cleaner assembly.
!
‘O’ RING
Fig.8/1
Fig.8/2
TABS
Fig.8/3
!
Vax U91-P3 User Guide.qxd:U91-P3 User Guide 15/12/08 09:34 Page 7