Vax V-006 Instruction Manual

Summary of V-006

  • Page 1

    Vax careline: 0870 6061248 please read carefully before using this cleaner. Always fully extend the mains cable before use. Www.Vax.Co.Uk bagless upright vacuum cleaner vax model number: v-006/v-006b/v-006n vax v-006 d5 bf 7/1/05 12:13 pm page 1 bagless upright vacuum cleaner vax model number: v-006...

  • Page 2

    1 cable clip 2 turbotool® 3 dirt container release latch 4 dirt container lid 5 hose tube 6 lower hose 7 lower hose cuff 8 clear dirt path window 9 handle 10 stair tool ( v-006u only) 11 crevice tool (inside extension tube) 12 extension tube 13 pleated hepa filter ( v-006b pleated filter) 14 dirt co...

  • Page 3

    Safety information 3 2. Safety information for household use only. When using the vacuum cleaner, basic safety precautions should always be observed, including the following: 1. Only use the vacuum cleaner indoors on dry surfaces. 2. Turn off the vacuum cleaner controls before connecting to or disco...

  • Page 4

    3. How to assemble important: always remove the power plug from the electrical outlet before assembling or before removing accessories. Tool required: phillips screwdriver. 1. Slide the back panel onto the base (fig.3/1). 2. To secure, insert the two (2) screws into the front of the back panel (fig....

  • Page 5

    5 12. Attach the tools. Slide the dusting brush onto the post in the upper tool caddy with the bristles facing out (fig.3/12a). Slide the extension tube/crevice tool into the round opening on the front of the right side of the tool caddy. Insert the stair cleaning tool into the top of the extension ...

  • Page 6

    15. To secure the dirt container push the top in place, there will be an audible click when it is secure (fig.3/15). 4. How to operate cord release release the power cord by turning the quick cord release. The cord should be inserted into the cord guide while vacuuming to keep it out of the way (fig...

  • Page 7

    5. Accessories important: the vacuum cleaner must be in the upright position to raise the brushbar. The brushbar height adjust must also be at its highest position. 1. Remove the hose from the tool caddy (fig.5/1). 2. Choose any of the handy on-board accessories or use the hose alone. Simply push th...

  • Page 8

    2. Remove the dirt container lid by turning it anti- clockwise (fig.6/2). 3. Hold the dirt container and grasp the top of the filter. Twist and pull the filter up and out (fig.6/3). 4. Empty the dirt container completely (fig.6/4). 5. Each time the dirt container is emptied, the filter should be cle...

  • Page 9

    2. Lift the nozzle guard (fig.7/2). 3. Lift and remove the brushbar and dispose of the belt (fig.7/3). To replace the belt or brushbar 1. Slide the belt onto the motorshaft (fig.7/4). Then slide the brushbar into the belt. 2. Place the new belt in the area of the brushbar without bristles (fig.7/5)....

  • Page 10

    2. Undo the hose from the back panel dirt tube. Remove any obstruction (fig.9/2). 3. Undo the hose from the clear dirt passage window and remove any obstruction (fig.9/3). 4. Remove the nozzle guard by removing the five (5) screws. Look for any obstructions and remove brushbar if necessary (fig.9/4)...

  • Page 11

    2. Pivot lowering housing and remove any blockage (fig.9/6). 3. To re-assemble, ensure that the tabs are engaged. Pivot the lower housing closed and rotate the locking ring 180º (fig.9/7). Fig.9/6 tabs fig.9/7 clearing blockages 11 vax v-006 d5 bf 7/1/05 12:13 pm page 11.

  • Page 12

    Troubleshooting 12 10. Troubleshooting warning: to reduce risk of personal injury, unplug vacuum cleaner before servicing problem: cleaner won’t run cause: not properly plugged into electrical outlet. Solution: plug in firmly. Cause: no electricity in electrical outlet. Solution: check fuse or break...

  • Page 13

    Troubleshooting/uk service & help/technical specification 13 12. Technical specification voltage: 230-240v ~50hz wattage: 1500-1900w (dependent on model) capacity: 4.2 litres max filters: pleated filter (some models hepa) fibre pre-motor filter cord length: 9.2m weight: 8.7kg subject to technical ch...

  • Page 14

    This page has been intentionally left blank. 14 vax v-006 d5 bf 7/1/05 12:13 pm page 14.

  • Page 15

    This page has been intentionally left blank. 15 vax v-006 d5 bf 7/1/05 12:13 pm page 15.

  • Page 16

    Eec statement of compliance manufacturer/eec importer: vax limited, hereby on our own responsibility, declare that the v-006 series bagless upright vacuum cleaners are manufactured in compliance with the following directives: safety: 73/23/eec low voltage directive emc: 89/336/eec electromagnetic co...