Vax V-024U Instruction Manual - page 7
7
Vax Careline
0870 606 1248
operation/ maintenance
Emptying the dirty water tank
Grasp the handle and hook the front of the dirty water
cleaner into the base, making sure that the front of the
dirty water tank is resting on the base.
The dirty water tank has three tabs on the underside
which MUST latch on to the underside of the base of the
cleaner. The base must be lifted so that the nozzle is
flush with the base of the cleaner.
Failure to install the dirty water tank correctly will result
in poor dirty water pick up (Fig 4/16).
While making sure the dirty water tank is resting on the
base, place the rear of the tank into the base of the
cleaner, push down on the handle until it latches.
Empty and rinse clean water tank after use (Fig 4/17).
5. Maintenance
Brush removal and replacement
NOTE: Phillips screwdriver required
NOTE: The plug must be removed from socket outlet
before cleaning or maintaining the appliance.
Remove the water tank switch off and unplug carpet
washer.
Flip the cleaner on its side to expose the nozzle base
(Fig 5/1).
To remove the brush access cover, use a Phillips
screwdriver to remove the two screws (Fig 5/2).
Lift out the floating brush bar (Fig 5/3).
Fig.4/15
Fig.4/16
Fig.4/17
Fig.5/1
Fig.5/2
Fig.5/3
V-024U User Guide v2.qxd:V-024U User Guide
12/3/08 08:47 Page 7