Vax V-027X Instruction Manual - page 13
Belt or brush removal
and replacement
Remove dirty water tank and front
nozzle (see page 20) put them to
one side.
Use a Phillips screwdriver to
remove two (2) screws.
Remove the belt cover. Remove the
broken belt.
4
1
Belt or brush removal
and replacement
1. Loop the belt around the rear shaft.
2. Loop the top of the belt above the small
pulley and the bottom of the belt around the
lower small pulley.
3. Feed the entire belt over the first large pulley.
4. Loop the belt around the front large pulley
and rotate the front brushbar forward until the
belt is in place.
Note: Make sure the entire belt stays on top of
the first large pulley by lightly placing a finder
on top to guide it.
Return the nozzle cover to the
original position.
Secure by replacing the two (2)
screws.
Remove the screw that holds the
brushbar in place.
23
5
Belt or brush removal
and replacement
Phillips screwdriver required
1
2
3
24
V-027X User Guide 7/9/06 15:04 Page 12