Uk service & help - vax care 0870 6061248 mon-fri. 9.00am to 5.00pm. An answer phone is available out of these hours. If you have queries or concerns about using your vax, call the helpline. Calls are charged at the uk national rate. Please make a note of the serial number and model number of your v...
2 1 hanging loop 2 vac on/off button 3 vac on/off lock 4 mid-handle grip 5 cleaning solution tank 6 dust canister release button 7 dust canister 8 mop head 9 vacuum cleaner nozzle 10 cleaning pads 11 charger 12 multi hard floor cleaner 13 solution dispensing trigger 14 solution tank release button 1...
3 to assemble the handle: insert the handle into the body of the unit and push down firmly until it locks into place. Be sure to line up the button on the handle with the notch on the body, to help guide the lower handle into the body. The pin should be visible in the hole on the body. Note: the vac...
Storage recommended use use the storage hook to hang the cleaner up. Note: hang in a place convenient for charging. Use the dry vacuum to remove loose dirt and debris from floors. Wet mop by dispensing the cleaning solution and using an absorbent pad to remove dirt and grime. 1 2 3 4.
5 operating the vac ‘n’ mop for advice on cleaning solutions and absorbent cleaning pads, please call vax care on 0870 6061248. Note: this product is intended for dry pick up only. Do not attempt to vacuum up any liquids with this cleaner. Prepare vac’n’mop lift the vacuum nozzle. It should lock int...
6 operating the vac ‘n’ mop prepare vac’n’mop unscrew the cap from the top of the cleaning solution tank. Mix one cupful of the multi hard floor cleaner per litre of water and pour into the solution tank. Replace the cap on the solution tank. Note: if needed, the solution tank can be removed from th...
7 operating the vac ‘n’ mop vacuum mop to turn the vacuum on: push the on/off button down (a). To lock the vacuum on: slide the lock button forward (b). Pull back with the thumb to unlock. To dispense the solution: pull the trigger on the back of the handle (c). For best results, clean one small are...
Dust canister and filter: removal important: for best results, clean the filter after each use. For advice on filter replacement, please call vax care on 0870 6061248 note: this product is intended for dry pick up only. However, if a wet spill is accidentally vacuumed into the dust canister, the fil...
9 dust canister and filter: removal return the filter to the filter protector and return to the dust canister. Re-attach by aligning the tab on the dust canister with the slot on the body of the unit. Tilt and push the dust canister until it locks into place. 15 16 17 tab slot.
Troubleshooting problem cleaner won’t run cleaner won’t pick-up/loss of suction cleaner won’t spray solution dust escaping from cleaner possible reasons 1. Battery not charged. 2. Handle not pushed into housing. 3. Battery dead - won’t hold a charge. 4. Needs service. 1. Dust canister full. 2. Filte...
Safety • do not use or charge the unit outdoors. • do not allow to be used as a toy. Close attention is necessary when used by or near children. • use only as described in this user guidel. • use only the manufacturer’s recommended attachments. • do not use the charger with a damaged cord or plug. •...
Eec statement of compliance manufacturer/eec importer: vax limited, hereby on our own responsibility declare that the product vac ‘n’ mop is manufactured in compliance with the following: safety: 72/23/eec low voltage directive as modified by 93/68/eec emc: 89/336/eec electromagnetic compatibility d...
