1. DL manuals
  2. Vax
  3. Vacuum Cleaner
  4. V-043
  5. Instruction Manual

Vax V-043 Instruction Manual

Other manuals for V-043: Instruction Manual
Manual is about: BAGLESS UPRIGHT

Summary of V-043

  • Page 1

    Eec statement of compliance manufacturer/eec importer: vax limited, hereby on our own responsibility declare that the product v-043 power reach is manufactured in compliance with the following: safety : 73/23/eec low voltage directive, as modified by 93/68/eec emc : 89/336/eec electromagnetic compat...

  • Page 2: Vax Careline:

    Vax careline: 0870 6061248 instruction manual please read carefully before using the cleaner. Always fully extend the mains cable before use. Www.Vax.Co.Uk bagless upright vacuum cleaner vax model number: v-043 v043_artwork.Qxd 30/3/06 12:01 page 2.

  • Page 3: 1. Diagram

    1. Diagram parts overview 1 4 5 6 9 11 8 7 2 17 16 18 15 14 front back 12 13 11 12 2 1 telescopic handle 2 on/off button 3 height adjuster button 4 dirt container lid 5 hepa filter 6 dirt container 7 brushbar height adjuster 8 vacuum head 9 wheel 10 foot pedal 11 power cord 12 auto cord rewind 13 ex...

  • Page 4: 2. Safety Information

    2. Safety information for household use only. When using the vacuum cleaner, basic safety precautions should always be observed, including the following: 1. Only use the vacuum cleaner indoors on dry surfaces. 2. Turn off the vacuum cleaner controls before connecting to or disconnecting from the mai...

  • Page 5: 4. How to Operate

    4. How to operate on/off pedal plug the cord into an electrical outlet. Turn the vacuum cleaner on by pressing the on/off switch located on the lower side of the cleaner (fig.4/1). The cleaner can be turned off by pressing the on/off switch again. Telescopic handle the telescopic handle allows you t...

  • Page 6: 5. Accessories

    To use the telescopic handle, release the handle by pushing the handle release button and attach the hose to the top of the telescopic handle (fig.5/3). Attach the desired accessory to the end of the telescope handle (fig.5/4). Accessories/dirt container & filter: removal & replacement 5 5. Accessor...

  • Page 7: 7. Rotating Brushbar:

    5. Firmly tap clean the hepa filter until no more dust is observed falling out (fig.6/5). Note: the white material in the hepa filter will discolour over time -this is normal and will not affect the performance of the filter. Warning: always empty the dirt container and clean the hepa filter before ...

  • Page 8: 8. Clearing Blockages

    3. Lift the right side of the brushbar and lift the left hand side and remove the brushbar from the vacuum cleaner head (fig.7/3). 4 . Remove the worn or broken belt from the motor drive shaft. 5. Carefully remove any belt residue that may exist in the belt area before replacing with a new belt. 6. ...

  • Page 9: 9. Troubleshooting

    8 troubleshooting 9. Troubleshooting w wa ar rn niin ng g:: to reduce risk of personal injury unplug vacuum cleaner before servicing problem: cleaner won’t run cause: not properly plugged into electrical outlet. Solution: plug in firmly. Cause: no electricity in electrical outlet. Solution: check fu...

  • Page 10: 10. Uk Service & Help

    9 troubleshooting 10. Uk service & help vax care 0870 6061248 monday-friday. 9.00am to 5.00pm. An answerphone will be available out of these hours. Any queries or concerns about using your vax, call the vax careline. Calls are charged at the uk national rate. Please make a note of the model number a...

  • Page 11

    10 v043_artwork.Qxd 30/3/06 12:02 page 11.

  • Page 12

    11 v043_artwork.Qxd 30/3/06 12:02 page 12.