Vax V-044B Series Instruction Manual - page 5
PLEASE KEEP THESE INSTRUCTIONS FOR
FURTHER USE.
3. Use & Function
To turn the vacuum cleaner on, press the ‘on’ switch.
To turn off, press the ‘off’ switch.
4. Vacuum Accessories
Accessories contained in vacuum cleaner
Two of the on-board accessories are stored in the
vacuum cleaner; the brush tool 7 and the crevice tool
5. They are positioned as shown in Fig.2.
For insertion of these tools into the suction
opening see Fig.3.
How to connect the connection piece
Before using, please check that ‘this side up BLOW’
and ‘this side up SUCK’ are shown on the two sides
of the universal adapter (part no. 4 ). Make sure the
suck side is uppermost when using as a cleaner
(Fig.4). This fitting is only suitable for suction.
Carpets & Hard Floors
The combination floor tool 3, has two positions, depending
on the floor type:
1.
Hard floors (tiles, parquet, etc): the brushes on the
combination floor tool must be lowered, by pressing
the rocker switch as shown in (a).
1.
Carpets or rugs: the brushes on the combination
floor tool must be raised, by pressing the rocker
switch as shown in (b).
NOTE: Make sure accessories are securely attached
before use.
5. Blower/Inflator Accessories
WARNING: Always wear eye protection when operating
as blower or inflator. Clean the vacuum before using for
blowing or inflating.
CAUTION: Make sure the accessories are securely
attached before use. When using the accessory hose for
blowing or inflating, hold the hose end securely before
turning ‘on’ and during use.
Fig.2
Fig.3
Fig.4
Fig.5
5
Use & Function/Vacuum Accessories/Blower/Inflator Accessories