Vax V-107APP Instruction Manual - page 7
7
Vax Careline
0870 606 1248
dirt container & filter / clearing blockages
NOTE: Do NOT use any detergents or boiling water to
wash the filter. Vax recommends washing the filter
every time you empty the dirt container.
Return the central filter to the dirt container and twist
until the filter is secure.
Return the dirt container to the vacuum cleaner.
Cleaning the Post-Motor Filter
NOTE: This is located at the back of the vacuum cleaner
Release the post-motor cover by pressing in the catch at
the top of the cover.
Remove the filter by pulling the filter away from the
casing (Fig.6/4).
The post-motor filter can be rinsed in warm water
(max 40°C). Allow to air dry for at least 24 hours before
replacing.
NOTE: Do NOT use any detergents or boiling water to
wash the filter. Vax recommends washing the filter
every 4 weeks.
Replace the post-motor filter in the case and re-fit to the
back of the vacuum cleaner.
7. Clearing Blockages
WARNING: To reduce the risk of electric shock,
the power cord must be disconnected before
performing maintenance or troubleshooting checks.
Turn the vacuum cleaner off and unplug from the electrical
outlet.
The flexible hose can be disconnected from the vacuum
cleaner by pushing in the button on the hose and pulling
away from the machine. Remove any blockages found then
re-connect the hose securely.
Removing debris from the TurboTool
Switch the vacuum cleaner off and disconnect the power
plug from the electrical outlet.
Rotate the locking ring 180º (Fig.7/1).
Lift the top cover off and remove any blockage (Fig.7/2).
To re-assemble, ensure that the tabs are engage. Pivot the
lower housing closed and rotate the locking ring 180º
(Fig.7/2).
Fig.6/3
Fig.6/4
!
LOCKING RING
Fig.7/1
TABS
Fig.7/2
Vax V-107APP User Guide.qxd:V-107 User Guide 24/9/08 12:28 Page 7