Vax V-123 Instruction Manual - page 10
www.vax.co.uk
10
maintenance
Rinse brushes under running water.
To replace, align posts on sides of brush assembly with
slots in cleaner. Turn brushes slightly to align square post
in the centre of the brush assebly with the square hole in
cleaner (Fig.6/4).
Press brush assembly firmly and snap in place.
Cleaning the Brush Filter
Unplug deep cleaner from electrical source.
Remove solution and recovery tanks to prevent possible
leaks.
Tilt cleaner back so handle rests on the floor.
Squeeze filter frame and pull it out until it stops (Fig.6/5).
Wipe debris off filter.
Slide filter back into place.
Storing the Cleaner
Empty solution tank and rinse thoroughly.
Place empty solution tank on deep cleaner. Turn deep
cleaner ON. Squeeze trigger and push deep cleaner
forward and back several times. This will clear any solution
remaining inside the cleaner.
Empty recovery tank, rinse thoroughly and let air dry.
Allow brushes and underside of deep cleaner to air dry
thoroughly before storing deep cleaner on a carpeted or
wood surface.
Fig.6/4
Fig.6/5
Fig.6/3
Vax V-123 User Guide.qxd 10/8/07 15:43 Page 10