Easy guide uk service & help - vax care 0870 6061248 monday to friday 9.00am to 5.00pm. An answer phone is available out of these hours. If you have queries or concerns about using your vax, call the helpline. Calls are charged at the uk national rate. Please make a note of the serial number and mod...
Parts check list a - carry handle b - on/off button c - motor housing unit d - cord winding recess e - release latches f - hose connector g - dust/dirty water container h - 360 o rotating castors i - flexible hose j - combination floor tool k - crevice tool l - dusting brush m - wet floor tool n - e...
1 2 how to assemble fig. 1 assemble the two piece extension tubes and the combination floor tool by pushing them together as shown. Fig. 2 to attach the flexible hose to the vacuum cleaner, push the connecting end of the flexible hose into the attachment point on the vacuum cleaner..
3 4 how to use attachments adjusting the combination floor tool for carpets & hard floors fig. 3 hard floor position (tiles, parquet floors etc) – the combination floor tool must be in the lower position. Press on the rocker switch to lower it (fig.3). Fig. 4 carpet or rug position – the combination...
5 6 preparing to use fig. 5 remove the top of the vacuum by releasing the side latches. Fig. 6 with both latches released, lift the top section away as shown..
7 8 operating your cleaner (for dry vacuuming) your vo-4000 vacuum cleaner can be used with either a disposable paper dustbag or with the re-usable bagless filter. All the accessories can be used whilst dry vacuuming. Important - ensure that either a paper dust bag or the re-useable bagless filter i...
9 10 11 operating your cleaner (for liquid spills) fig. 9 only use the wet floor tool when sucking up water. Important - ensure the paper dust bag or the re-useable bagless filter is removed. - ensure there is no remaining water in the hose and tubes before switching off the appliance. - ensure that...
12 13 15 14 emptying the dust bag/dirty water container fig. 12 unclip release latches. Fig. 13 lift out motor housing unit. Fig. 14 for dry - remove dust bag or re-uasable bagless filter and empty as normal. Fig. 15 for wet - lift dirty water container by handle and dispose of contents..
16 17 how to use fig. 15 fully unwind the mains cable and plug it into a standard domestic socket outlet. Fig. 16 to start the vacuum cleaner, press the on/off switch. To stop, press again..
Cleaning the filter motor protection filter fig. 17 the filter is located on the underside of the vo-4000 top section as shown protects the motor from dust and debris. This filter can be lightly swilled under cold water to remove any debris. Ensure this is completely dry before replacing. Attention:...
Important notes/ troubleshooting 1) if the suction is significantly reduced, the filter may require cleaning. 2) during wet vacuuming, if the float rises and blocks suction, you will notice the change in the sound that the machine makes. This is a safety feature and is intended to prevent continued ...
Important safety information • do not use the dry vacuuming accessories whilst vacuuming water. • always remove the re-useable bagless filter/paper dust bag before wet vacuuming. • do not dry vacuum without the re-useable bagless filter or paper dust bag in place. • ensure that all accessories, filt...
Important safety information • not to be used as a toy • use the appliance only as described in the easy guide • use only the accessories recommended by the manufacturer • do not use the appliance with a damaged mains cable or plug. • do not use the appliance if it has been dropped, damaged, left ou...
Uk service & help – vax care 0870 6061248 mon – fri. 9:00am to 5:00pm. An answerphone is available out of these hours. If you have queries or concerns about using your vax, call the helpline. Calls are charged at the uk national rate. Please make a note of the serial number and model number of your ...
