Vax VX49 Let's get started - Using Your Machine
SETUP the Cleaner from DRY to WET Vacuuming
NOTE: Empty the tank and dispose of any dirt/dust which may have been picked up previously in dry mode.
NOTE: Clean and dry the inside and outside of the machine before storage.
IMPORTANT: Never vacuum dry dust and dirt with just this foam fi lter fi tted as it will provide little or no protection,
resulting in motor damage. To be used in wet mode only.
When vacuuming up fl uids
– the crevice nozzle can be
used when the water level
is too high to use the fl oor
tool. To ensure the
air fl ow is adequate, we
recommend that the end
of the nozzle is not totally
immersed.
Once the water tank is
emptied, place the top
motor housing cover back
onto the main tank and
secure into position with
the two retaining clips.
Connect the vacuum
cleaner to the power supply
and switch ON
by pushing the on/off
switch “I” to continue
to vacuum in wet mode.
When the fl uids have
reached the maximum tank
capacity, the fl oat regulator
will cover the motor fi lter
causing the motor to work
harder and it will become
noticeably nosier. At this
point turn off the machine
and unplug it from the mains
power and empty the tank.
Remove the dry fi lter and
replace it with the foam
fi lter – this slides over the
fl oat cage as shown.
Place the top motor housing
cover onto the main tank
and secure into position
with the two retaining clips.
Remove dust bag from
tank.