Vax VZ-302 Instruction Manual - page 4
3.HowtoAssemble
IMPORTANT: Always unplug the vacuum
cleaner from the electrical outlet before
assembling or removing the accessories.
1. Insert the flexible hose (Fig.3/1) into the
inlet on the main body of the vacuum
cleaner until it clicks into lock position.
2. Push the telescopic extension tube on to
the end of the handle (Fig.3/2).
3. The telescopic tube can be lengthened
or shortened by pushing the button in
and sliding the tube apart or together as
required (Fig.3/3).
4. Fit the combination floor head by pushing
onto the extension tube (Fig.3/4).
4.HowtoOperate
CordRelease
Fully unwind the power cord. A yellow mark on
the power cord indicates the recommended
cord length. Do not exceed the cord length
beyond this mark.
On/offButton
1. Insert the plug into the electrical outlet.
2. Press the on/off switch located on the
top of the vacuum cleaner, to switch on
the vacuum cleaner and press the button
again to turn the vacuum cleaner off.
CarpetCleaning
For carpet and rug cleaning, press the rocker
switch on the combination floor head to raise
the brushes.
HardFloorCleaning
For hard floor cleaning, press the rocker
switch on the combination floor head to lower
the brushes.
CordRewind
To rewind the power cord, press the cord
rewind button located on the top of the
vacuum cleaner, and guide the power cord
with one hand. Rewind 1-1
1
/
2
metres of cord
at a time. This will prevent the cord from
whipping which could cause damage or
injury.
CarryHandle
Use the carry handle located at the rear end
of the vacuum cleaner to move from room to
room.
HoseStorage
For convenience there is a parking slot located
at the rear of the vacuum cleaner where the
floor tool and hose can be parked for carrying
and storage.
4
5
5.Accessories
1. The accessories can be attached directly to
the handle by removing the telescopic tube
and pushing in the desired accessory.
2. The accessories can also be attached to
the telescopic extension tube for extra
reach. Remove the combination floor head
and push on the desired accessory.
Dustingbrush: for delicate surfaces
Upholsterytool: for carpet, upholstery and
stairs etc.
Crevice tool: for crevices, corners and
cracks, etc.
6.DirtContainer&Filters:
Removal&Replacement
IMPORTANT: Always unplug the vacuum
cleaner from the electrical outlet before
removing the dirt container.
IMPORTANT: Do NOT use the vacuum
cleaner without ALL of the filters in place.
Emptyingthedirtcontainer
1. Press down the dirt container release
button located on the top of the vacuum
and lift the dust container to remove.
2. Hold the dirt
container over a bin
and press the quick
release buttons to
empty the container
(Fig.6/2).
The top button
empties finer dust
& the bottom button
empties larger dirt.
3. Tap and shake the bin to remove all the
dust and dirt from this container.
4. Once all the dust is removed, carefully close
the dirt container flap. A click will be heard
when closed. Replace the dirt container.
Cleaningthecycloneseparator
1. Twist and pull the dirt container bin off the
cyclonic separator. The dirt container bin
may be wiped clean.
2. The separator should be cleaned with a
soft brush and wiped with a damp cloth.
3. Leave the separator to dry completely
before replacing.