Vax VZL-7022 Instruction Manual - page 6
www.vax.co.uk
6
dirt container and filters / clearing blockages
2.
The separator should be cleaned with a soft brush
and wiped with a damp cloth. The dirt container bin
may be wiped to clean.
3.
Leave the separator to dry completely before
replacing.
IMPORTANT: The cyclonic separator should not be
submerged in water.
NOTE: Do NOT use any detergents or boiling water to
wash the filters. Vax recommends cleaning the filter
every time you empty the dust container.
4.
Replace the dirt container as directed.
Cleaning the pre-motor filter
NOTE: This is located underneath the dirt container bin.
1.
Release the pre-motor filter cover by lifting up the
tab. Lift off the filter cover to gain access to the filter.
Remove the filter by pulling the tab towards you.
2.
Separate the foam filter from the fabric cassette.
Each filter can be tapped against the side of a dust
bin to remove the excess dirt and dust.
3.
The pre-motor filters may be rinsed in warm water
(max 40 deg.). Allow to air dry for 24 hours before
replacing.
NOTE: Do not use any detergents or boiling water to
wash the filter. Vax recommends this filter should be
checked and cleaned periodically.
4.
Once completely dry, return the pre-motor filters and
cassette to the vacuum cleaner. Replace the pre-
motor filter cover before restarting the vacuum
cleaner.
Cleaning the Post-motor filter
NOTE:This is located on the rear of the vacuum cleaner.
1.
Release the post-motor filter cover and remove the
cover as shown. Remove the filter by pulling the tab
towards you.
2.
The filter can be tapped
against the side of a dust
bin to remove the excess
dirt and dust.
3.
The post- motor filter may
be rinsed in warm water
(max 40 deg.). Allow to air
dry for 24 hours before
replacing.
NOTE: Do not use any detergents or boiling water to
wash the filters. Vax recommends washing the filter.
Vax recommends washing the filter every 9-12 months.
4.
Once completely dry, return the post-motor filter to
the vacuum cleaner. Replace the post-motor filter
cover before restarting the vacuum cleaner.
Fig.6/5
Fig.6/6
Fig.6/7
Fig.6/8
Fig.6/4
Vax VZL-7022(HF).qxd:Vax VZL-7022HF User Guide 10/4/08 14:50 Page 6