Vax W87-RH-P User manual - Vax.Co.Uk
vax.co.uk
5
How To Use
Before you begin cleaning
Do not saturate your carpet.
• Vacuum your carpets thoroughly.
• Test for colourfastness – Wet a white absorbent cloth with the solution. In a small, hidden area of your carpet, gently rub the
surface with the dampened cloth. Wait ten minutes and check for colour removal or bleed with white paper towel or cloth. If your
carpet has more than one colour, check all colours.
• When cleaning an entire room, move furniture out of the area to be cleaned. If the furniture is too heavy to move, place aluminium
foil or wax paper under legs. This will prevent wood finishes from staining your carpet. Pin up furniture skirts and curtains.
IMPORTANT: Only use Vax carpet cleaning solution. Using other solutions may cause excess foaming. Excessive foam will prevent
the machine from working effectively. Using other solutions will invalidate the guarantee.
Operating your pre-treatment wand
Pour required dose of
pre-treatment solution
(approx.40ml per 1.0L of water).
Pre-treating your carpet before washing will help to remove stubborn stains. Do not saturate your carpet.
Mix solution with warm
water. (max 40°C).
Remove clean water tank.
Fill clean water tank with
solution mix.
Tighten cap before
returning tank to unit.
Unwrap power cord and plug unit in.
Remove pre-treatment
wand from holder.
Attach pre-treatment tube by
alligning inserts and pushing
in. Turn clockwise to secure.
Spray evenly onto desired areas
and leave for 10-15 minutes
before washing carpets.