Vector 4/10/20/50 Amp 12 Volt Smart User's Manual & Warranty Information

Summary of 4/10/20/50 Amp 12 Volt Smart

  • Page 1

    Five year limited warranty program this limited warranty program is the only one that applies to this product, and it sets forth all the responsibilities of vector manufacturing, ltd., regarding this product. There is no other warranty, other than those described herein. This vector manufacturing, l...

  • Page 2

    Iii ii if a properly grounded outlet is not available, a temporary adapter (like the adapter shown in figure1b) may be used to connect this plug to a two-pole receptacle. The temporary adapter should be used only until a properly grounded outlet can be installed by a qualified electrician. Danger — ...

  • Page 3

    1 table of contents introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 controls and indicators . . . . . . . . . . . . . ...

  • Page 4

    3 controls and indicators function buttons (from left to right): battery type (step 1) — allows the user to select wet, gel or agm type of battery for efficient and safe charge. Most automotive batteries are wet batteries. Refer to the battery manufacturer’s specifications for battery type. 4/10/20/...

  • Page 5

    5 note: the only time the selected charge rate does not display at the full selected rate is when the battery is nearly full and charging at either step two or three. The display will be showing a reduced charge rate. To return to 2a, press the 2/20/50 amp button. When the battery is fully charged, ...

  • Page 6

    7 10. Push the equalize button at any time and the battery will automatically begin to equalize in 4 amp limited current. Note that in order to push the recessed button you will need a small pin or ballpoint pen. 11. Every hour, the temperature should be checked by touching the battery. If the batte...

  • Page 7

    9 the times shown in the table above are approximate and refer to a 50 ah automotive battery. For example, a 50 ah (12 volt) battery is discharged (50%). How long should it be charged at the 10 amp rate? See the chart above under “50%” and “at 10 amp rate.” in most cases, battery charging times will...

  • Page 8

    11 10 f03 — sulfate or unchargeable battery f03 appears when the battery is highly sulfated and cannot accept normal charge current. • follow the steps in “recondition mode” to recondition the battery. • follow the steps in “equalizing” to equalize the battery. • if the situation persists after reco...