Owner’s manual & warranty information this manual contains important information regarding safety, operation, maintenance and storage of this product. Before using, read and understand all cautions, warnings, instructions and product labels, plus your vehicle's battery manufacturer guidelines. Failu...
Important safety instructions to ensure reliable service, your power inverter must be installed and used properly. Please read the installation and operating instructions thoroughly prior to installation and use. Pay particular attention to the warning and caution statements in this manual. The caut...
Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 2. Controls, indicators and connectors . . . . . . . . . . . . . . . . . . . . . . 4,5 3. How your inverter works . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 3.1 principal o...
1. Introduction your new vector maxx 750 sst inverter is one in a series of the most advanced dc to ac inverters available. With proper care and appropriate usage, it will give you years of dependable service in your car, truck, rv or boat. The maxx 750 sst supplies 750 watts of continuous power, wi...
Figure 2 - shows location of the cooling fan and dc terminals 3. How your vector inverter works the inverter converts low voltage dc (direct current) from a battery or other power source to standard 110 volt ac (alternating current) household power. 3.1 principle of operation the inverter converts p...
The modified sine wave produced by the maxx 750 sst inverter has an rms (root mean square) voltage of 110 volts, which is the same as standard household power. Most ac voltmeters (both digital and analog) are sensitive to the average value of the waveform rather than the rms value. They are calibrat...
Caution: reverse polarity connection will result in a blown fuse and may cause permanent damage to the inverter. Connecting to a power source using provided cables: use the provided cables to connect the maxx 750 sst directly to the 12 volt power source using the following guidelines: 1. Check to be...
4.3 connection to load the maxx 750 sst is equipped with dual standard north american ac power receptacles. Plug the cord from the equipment you wish to operate into the ac receptacle(s). The green led indicator lights to indicate that the inverter is functioning. Make sure the combined load require...
5. Operating tips 5.1 rated versus actual current draw of equipment most electrical tools, appliances and audio/video equipment have labels that indicate the power consumption in amps or watts. Be sure that the power consumption of the item you wish to operate is rated at 750 watts or less (if the p...
Over voltage protection - the maxx 750 sst will automatically shut down when the input voltage exceeds 15.5 volts dc. Short circuit protection - reverse polarity or a short circuit condition will usually result in an external or internal fuse being blown. Overload protection - the inverter will auto...
8. Troubleshooting guide table 1 - inverter power switch turned on trouble/ indication possible cause suggested remedy no ac output – dc input below 10 volts recharge or replace red led lit battery no ac output – excessive appliance reduce load-wait for red led lit load-thermal shutdown inverter to ...
10. Specifications output connection . . . . . . Dual north american standard receptacles output voltage . . . . . . . . . . . . . . . . Approx 110 volt ac rms 60 hz output current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.8 amps output waveform . . . . . . . . . . . . . ...
If the extended warranty was activated, this repair or replacement period extends to four years from the purchase date. If the unit is repaired, new or reconditioned replacement parts may be used, at vector manufacturing’s option. A unit may be replaced with a new or reconditioned unit of the same o...
© 2004 vector manufacturing, ltd. Ft. Lauderdale, fl 33312 made in china.
