Vector BD051605 User's Manual & Warranty Information

Summary of BD051605

  • Page 1

    Power on board 2 year limited warranty program this limited warranty program is the only one that applies to this product, and it sets forth all the responsibilities of power on board, regarding this product. There is no other warranty, other than those described herein. This power on board product ...

  • Page 2

    Iii ii compressor/inflator safety 1. Never attempt to disable or block the inflation and deflation ports while pump is operating. 2. Never cover unit at any time. 3. Never leave the pump unattended while in use. 4. Never allow sand, small rocks or other debris to be sucked into the inflation or defl...

  • Page 3

    1 table of contents introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 ac and dc charging/recharging . . . . . . . . ...

  • Page 4

    3 front panel ac and dc charging/recharging use a common household ac extension cord for charging (cord not supplied). For maximum battery life, we recommend the unit be kept fully charged at all times. If the battery is allowed to remain in a discharged state, battery life will be shortened. • make...

  • Page 5

    5 jump-starting instructions this jump-starter is equipped with a manual safety switch that only allows jump-start energy to flow when proper connections are made to battery and frame. Connect — red clamp first, then black clamp. Disconnect — black clamp first, then red clamp. 1. Turn off vehicle ig...

  • Page 6

    7 using the emergency area light the area light is controlled by an on/off pushbutton. Make sure the light is turned off when the unit is being recharged or stored. Using the air compressor/inflator the built-in 12 volt dc air compressor is the ultimate inflator for all vehicle tires, trailer tires ...

  • Page 7

    9 deflating 1. Open the valve on your product completely to release air. 2. Fasten the inflator/deflator hose (stored in the compartment on the back of the unit — see page 2) to the deflator port inside the air panel. 3. Attach the appropriate nozzle to the free end of the inflator/deflator hose. 4....

  • Page 8

    11 10 specifications 12 volt dc specifications battery: 12 volt dc rechargeable, maintenance-free internal battery type: sealed, agm lead-acid internal battery capacity: 12 volt, 19ah/20 hour rate area light : light emitting diode (led) jumper cables: heavy duty welding cable with 450 amp clamps acc...