Vector MAXX SST VEC049GM User's manual & warranty information

Manual is about: Portside Power Inverters Converts 12 Volt DC to 110/120 Volt AC Advanced MOSFET Technology

Summary of MAXX SST VEC049GM

  • Page 1

    16 vec049gm vec050gm vec051gm user’s manual & warranty information important safety information, save these instructions to reduce the risk of injury, user must read and understand this instructional manual. This manual contains important information regarding the operation and warranty of this prod...

  • Page 2

    Important cable information substantial power loss and reduced battery operating time results from inverters installed with cables that are not able to supply full power. Symptoms of low battery power can result from cables that are either excessively long or an insufficient gauge. Marine installati...

  • Page 3

    1 table of contents introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 vec049gm functions...

  • Page 4

    2 • a special moisture barrier, a conformal coating, that protects the internal circuit board from failing from excess humidity conditions. • ground fault circuit interrupt outlets • installation instructions especially geared for marine applications. Built-in safety features include: • automatic ov...

  • Page 5

    5 modified sine wave and sine wave comparison appliance power consumption maxx sst ™ portside power inverters are ideal for powering: • lights • tvs and tv/dvd (vcr) combinations units • radio receivers/transceivers and stereo systems • computers and peripheral equipment • refrigerator/freezers • sm...

  • Page 6

    7 connections are good and the battery is charged, but the voltage still drops below 11 volts, you may need to use a larger battery (or battery combination). Caution rechargeable devices certain rechargeable devices do not operate well from a modified sine wave inverter. They only operate properly f...

  • Page 7

    9 note: all operating time curves assume permanent installation with the appropriate dc input wire (see the “specifications” section on page 16) and a full charge on the batteries. For example, as shown in the above graph, using a 400 a/h battery (batteries), if the average power usage will be 1000 ...

  • Page 8

    11 only connect the inverter’s dc input to existing wiring (which must be approved for marine use) at the appropriate gauge, cable and length (see the “specifications” section, page 16). For cable lengths exceeding 6 feet from inverter to batteries, call vector for additional installation informatio...

  • Page 9

    13 4. Measure the cable twice before cutting the cable. 5. Cut one cable length to connect the negative (–) battery terminal to the inverter’s negative terminal, leaving a little slack in the cable. 6. Cut another cable to connect the positive (+) battery terminal to one side of fuse holder, leaving...

  • Page 10

    15 troubleshooting common audio/visual problems “buzzing” sound in audio systems some inexpensive stereo systems and “boom boxes” emit a buzzing sound from their speakers when operated from the power inverter. This occurs because the power supply in the electronic device does not adequately filter t...